In-service the degradation of compressor blade leading edges can have a disproportional effect on compressor efficiency. The high surface curvature in this region makes quantifying the surface finish of this sensitive and prominent region difficult. An automated technique that characterises the roughness of the leading edge in terms of areal parameters is presented. A set of ex-service blades o...

Abstract—The wear measuring and wear modelling are fundamental issues in the industrial field, mainly correlated to the economy and safety. Therefore, there is a need to study the wear measurements and wear estimation. Pin-on-disc test is the most common test which is used to study the wear behaviour. In this paper, the pin-on-disc (AEROTECH UNIDEX 11) is used for the investigation of the effec...

There is a direct relationship between the efficiency of mechanized excavation in hard rocks and that of disc cutters. Disc cutter wear is an important effective factor involved in the functionality of tunnel boring machines. Replacement of disc cutters is a time-consuming and costly activity that can significantly reduce the TBM utilization and advance rate, and has a major effect on the total...

The lubrication regime in which artificial hip joints operate adds complexity to the prediction of wear, as the joint operates in both the full fluid film regime-specifically the elastohydrodynamic lubrication (EHL) regime-and the mixed or boundary lubrication regimes, where contact between the bearing surfaces results in wear. In this work, a wear model is developed which considers lubrication...

Glass fiber reinforced plastic composite materials are finding increased applications due to their excellent properties. Fiber reinforced plastic (FRP) composite materials comprise soft matrix and fiber elements. This article presents the tribological aspects of glass fiber reinforced plastic composites. The wear test is carried out for FRP in a pin-on-roller wear tester. The wear rate obtained...

The abrasive wear of nanocrystalline Ni–W alloys with grain sizes of 5–105 nm has been studied using Taber abrasion testing. The wear resistance of the finest grain size specimen is found to be higher than would be predicted based on hardness alone. This deviation from Archard scaling is traced to mechanically-driven structural evolution, consisting of grain growth and grain boundary relaxation...

Resumption of daily living activities is a basic expectation for patients provided with total knee replacements. However, there is a lack of knowledge regarding the impact of different activities on the wear performance. In this study the wear performance under application of different daily activities has been analyzed. In vivo load data for walking, walking downstairs/upstairs, sitting down/s...

In the present study, enamel wear against indirect composite resins was evaluated using two newly designed wear test methods: a rotating sliding wear test and a buff wear test. For the composite resins investigated in this study, their surface morphologies were examined using a scanning probe microscope after buff-polishing. After the wear tests, enamel was worn down by hard fillers that protru...

If one of the surfaces which are in touch is rough and hard, it chips the other surface due to relative motion or touching forces. The wear is called two-body abrasive wear. If there are free abrasive particles between the two bodies, the wear is called three-body abrasive wear. The free abrasive particles may be external material dust or the remains of chipping. Usually, the wear starts as a t...