OBJECTIVE To investigate the effect of various fluoride compounds and casein phosphopeptide/amorphous calcium phosphate (CPP-ACP) on the reduction of erosive/abrasive tooth wear. METHODS Forty enamel samples were prepared from bovine lower incisors, stratified and allocated to 4 groups (1-4). Samples in group 1 remained untreated and served as negative controls. The test samples were treated ...

The selection of optimum process parameters is crucial for advanced machining processes, as these processes incur high initial investment, tooling cost, and operating and maintenance costs. In this paper, a review of machining process parameters for different materials is done in ultrasonic machining (USM). Machining of Different materials like ceramics, Glass Porcelain, Titanium, is done by di...

The paper studies the polishing power of a tribochemically active abrasive material based on solid solution iron and aluminum oxides, as well oxides modified by zirconium oxide yttrium additives, tribotechnical properties lubricant doped with these materials. Al2O3·Fe2O3·ZrO2·Y2O3 powders prove to have an essentially higher producing considerably lower surface roughness than that unmodified Al2...

This paper reports on the evaluation of a high resolution micro ultrasonic machining (HR-μUSM) process suitable for post fabrication trimming of complex 3D microstructures made from fused silica. Unlike conventional USM, the HR-μUSM process aims for low machining rates, providing high resolution and high surface quality. The machining rate is reduced by keeping the micro-tool tip at a fixed dis...

This paper presents a review on the problems encountered in machining titanium and application of USM in machining titanium and its alloys. Experiments have been conducted to assess the effect of three factors-tool material, grit size of the abrasive slurry and power rating of ultrasonic machine on machining characteristics of titanium (ASTM Grade I) using full factorial approach for design and...

In the present research work, the effect of several process parameters on the machining characteristics of pure titanium (ASTM Grade-I) has been reported. The machining characteristics that are being investigated are tool wear rate and the quality of the machined surface in terms of the surface finish. The mechanism of material removal was has also been correlated with the machining conditions....

Surface quality including surface roughness and edge chipping is a key process measure in micro ultrasonic machining (Micro-USM) as an efficient process for micromachining of hard and brittle materials. Process parameters such as ultrasonic vibration amplitude, static load, type of tool material, type and size of abrasive particles and slurry concentration can influence the surface quality. How...