Three samples of bituminous material with different softening temperatures 321, 332, and 356.4 K were obtained by the method chemical modification tar formaldehyde using sulfuric acid as a catalyst. The determination group hydrocarbon composition was carried out for raw materials process (tar) resulting bitumens. An FTIR study groups hydrocarbons (oil, resins, asphaltenes) also out. structural ...

In the present study, an attempt is made to find usage and utilization of by-products or recycledmaterials in bituminous paving mixes. The experiment started with conduction basic tests for various materials like Coarse aggregate, Fine Bitumen, by-product recycled copper slag, foundry sand, brickbats. These were tested their suitability carrying out work as a prediction know alternative these m...

Lignin fibers typically influence the mixture performance of stone matrix asphalt (SMA), such as strength, stability, durability, noise level, rutting resistance, fatigue life, and water sensitivity. However, limited studies were conducted to analyze the influence of fibers on the percent voids in mineral aggregate in bituminous mixture (VMA) during the mixture design. This study analyzed the e...

Six Integrated Gasifi cation Combined-Cycle (IGCC) power plant confi gurations operating on bituminous coal were evaluated and the results are presented in this summary sheet. All cases were analyzed on the same basis, using a consistent set of assumptions and analytical tools. Each gasifi er type was assessed with and without carbon capture and sequestration (CCS). The individual confi guratio...

In anticipation of the introduction of high modulus materials in the Swiss standards, a research project has been carried out for the evaluation of these bituminous mixtures. These mixtures make possible to reduce rut in base courses. With a temperature of 50°C, three test sections (two with high modulus and one with a reference material for base layer), were built in a building for ALT and wer...

Four different types of coal have been pyrolyzed in a laminar flow, drop tube furnace in order to establish a relationship between polycyclic aromatic compound (PAC) evolution and mutagenicity. Temperatures of 900K to 1700K and particle residence times up to 0.3 sec were chosen to best simulate conditions of rapid rate pyrolysis in pulverized (44-53 microns) coal combustion. The specific mutage...

Over the last few years the Texas Department of Transportation has expressed concern about mineralogical segregation (variation) of coarse aggregates used in bituminous mixes; problems are associated with variation in the quality of aggregates taken from a quarry/gravel pit. The primary objective of this project was to examine the effects of poor quality coarse limestone aggregate on hotmix asp...