This paper described the discovering process of some shortcomings of the conventional fluid catalytic cracking (FCC) process and the proposed two-stage riser (TSR) FCC process for decreasing dry gas and coke yields and increasing light oil yield, which has been successfully applied in 12 industrial units. Furthermore, the multifunctional two-stage riser (MFT) FCC process proposed on the basis o...

In a naphtha distillation process, the natural objective is to perform an entire process maximization of the production rate while meeting required product qualities by searching for an optimal operating condition by manipulating the operating variables. The objective of this paper includes performing an energy process optimization. Not only is an adequate production rate met with the required ...

For the new process of effective utilization of energy, chemical recuperation of low-grade exhaust heat by steam reforming of dimethyl ether (DME) was proposed. Steam reforming of DME is an endothermic reaction as; DME + 3H2O + 122[kJ/mol] → 6H2 + 2CO2. If this reaction could be proceed by exhaust heat below 573 [K], those exhaust heat which is wasted to ambient would be recuperated as the fuel...

This paper documents the application of exhaust gas fuel reforming of two alternative fuels, biodiesel and bioethanol, in internal combustion engines. The exhaust gas fuel reforming process is a method of on-board production of hydrogen-rich gas by catalytic reaction of fuel and engine exhaust gas. The benefits of exhaust gas fuel reforming have been demonstrated by adding simulated reformed ga...

Catalytic steam reforming of glycerol for H(2) production has been evaluated experimentally in a continuous flow fixed-bed reactor. The experiments were carried out under atmospheric pressure within a temperature range of 400-700 degrees C. A commercial Ni-based catalyst and a dolomite sorbent were used for the steam reforming reactions and in situ CO(2) removal. The product gases were measured...

A series of nickel-containing mesoporous silica samples (Ni-SiO₂) with different nickel content (3.1%-13.2%) were synthesized by the evaporation-induced self-assembly method. Their catalytic activity was tested in carbon dioxide reforming of methane. The characterization results revealed that the catalysts, e.g., 6.7%Ni-SiO₂, with highly dispersed small nickel particles, exhibited excellent cat...

The activation and catalytic performance of two representative Zr-containing intermetallic systems, namely Cu-Zr and Pd-Zr, have been comparatively studied operando using methanol steam reforming (MSR) as test reaction. Using an inverse surface science and bulk model catalyst approach, we monitored the transition of the initial metal/intermetallic compound structures into the eventual active an...

The effect of ruthenium on the physico-chemical properties of CeZr and CeZrCo mixed oxides for H2 production by glycerol steam reforming reaction has been studied. The combination of in situ Raman spectroscopy under both reductive and oxidative conditions, H2/O2 pulses and XRD, Raman, BET analysis, H2-TPR and TPD-TPO analyses contributed to the determination of the structural and textural prope...

10-membered ring IM-5 zeolite has shown excellent performance in many catalytic reactions. The efficient preparation of high silica by situ synthesis remains huge challenge. Here, with SiO2/Al2O3 ratio (SAR) 49–116 was acquired HNO3 treatment. An interesting stepwise dealumination behavior discovered during the whole acid-treatment process (based on XRF characterization). Extra-framework Si (EF...

Abnormal growth of population and development enormously increases energy demand. In present scenario utilization of fossils fuels to meet this demand is not enough and also leads to pollution, global warming, climate change as well as natural disaster. Therefore, hydrogen as energy carrier is a major option on these prospects as it is non-polluting and renewable. The renewable hydrogen energy ...