This article proposed a novel topology of dynamic voltage regulator using transformer and PWM multi-level AC/AC converter. In this paper for finding the best value of duty ratio for switches to minimize the THD, the GA algorithm has been used and THD output voltage is assumed to be fitness function. The proposed voltage regulator employs multi-level AC/AC converter to generate compensation volt...

A soft switching three-transistor push-pull(TTPP)converter is proposed in this paper. The 3rd transistor is inserted in the primary side of a traditional push-pull converter. Two primitive transistors can achieve zero-voltage-switching (ZVS) easily under a wide load range, the 3rd transistor can also realize zero-voltage-switching assisted by leakage inductance. The rated voltage of the 3rd tra...

The influence of surface stress and small scale on the dynamic pull-in behavior of nano-bridges is investigated in this paper. For this purpose, the governing equation of motion is derived based on the modified couple stress theory and Homotopy Perturbation Method with an auxiliary term is employed to produce the approximate solution of nano-beam vibrations. The effects of actuation voltage, in...

This article deals with effects of thermal stresses on stability and frequency response of a fully clamped circular microplate, which acts as the diaphragm of a capacitive MEMS microphone. Static and dynamic pull-in phenomena limit the stable regions of a capacitive MEMS microphone. The results show that the non-dimensional static pull-in voltage of the studied case is about 5.23 (38.6 V). On t...

A compact dc/ac inverter for automotive is presented and experimented. The proposed inverter consists of fall bridge inverter and a new ZVCS quasi-resonant push pull dc/dc converter. The new dc/dc converter converts input 12 V (from battery) to high voltage (about) 200V at very high conversion efficiency without regulation. The high voltage will be converted to ac at the desired voltage and fre...

The pull-in voltage instability associated with a simple MEMS device, consisting of a thin dielectric elastic membrane supported above a rigid conducting ground plate, is analyzed. The upper surface of the membrane is coated with a thin conducting film. In a certain asymptotic limit representing a thin device, the mathematical model consists of a nonlinear partial differential equation for the ...

In this study, a novel variable impedance control for a lower-limb rehabilitation robotic system using voltage control strategy is presented. The majority of existing control approaches are based on control torque strategy, which require the knowledge of robot dynamics as well as dynamic of patients. This requires the controller to overcome complex problems such as uncertainties and nonlinearit...

In this paper, we propose the design of low power level-converting retention flip-flop (RFF)using LSSR technique for Zigbee System-onchips (SoCs).The proposed retention flip-flop allows the voltage regulator which generates the core supply voltage (VDD, core) is turned off during the standby mode and thus reduces the standby power and dc current of the Zigbee SoCs. This method is the combinatio...