Self-organization of dislocation structures, slip line and band patterning, and macroscopic plastic instabilities are typical manifestations, at different scales of observation, of nonlinear cooperative phenomena. This general aspect is discussed with emphasis on the relations between the dynamic properties of dislocations, their collective behavior, the local plastic properties of a material a...

A dual phase Ti-6A1-4V alloy was tested in uniaxial tension over a large quasi-static loading range (10−5–10−1 s−1) in ambient environment. As strain rate increases, strength of the alloy was found to increase at the expense of ductility. In the low strain-rate region, strain rate sensitivity of the material experienced a gradual decrease during plastic deformation. In the high strain-rate regi...

Since tubes have numerous industrial applications, different attempts are focused on the severe plastic deformation processes of tubes. As an illustration, tube channel pressing (TCP) is an attractive process for this purpose since it can be used for processing of different sizes of tubes. However, more attempts are needed to improve the outcomes of TCP. For example, imposing of a greater strai...

This paper investigates the elastic-plastic seismic behavior of long span cable-stayed steel bridges through the plane finite-element model. Both geometric and material nonlinearities are involved in the analysis. The geometric nonlinearities come from the stay cable sag effect, axial force-bending moment interaction, and large displacements. Material nonlinearity arises when the stiffening ste...

[1] We extend an elastodynamic finite element method to incorporate off-fault plastic yielding into a dynamic earthquake rupture model. We simulate rupture for models of faults with a kink (a sharp change in fault strike), examining how off-fault plastic yielding affects rupture propagation, seismic radiation, and near-fault strain distribution. We find that high-frequency radiation from a kink...

In hot forming process, the workpiece undergoes plastic deformation at high temperature and the microstructure of the workpiece changes according to the plastic deformation. These changes affect the mechanical properties of workpiece. In order to optimize this process, both the plastic deformation of workpiece and its microstructural changes should be taken into consideration. Since material be...

Parallel tubular channel angular pressing (PTCAP) process is a novel recently developed severe plastic deformation technique for fabrication of ultrafine grained (UFG) metallic tubes. This new process consists of two half cycles and is affected by several parameters such as channel angles, deformation ratio and curvature angles. In this paper, the effects of these parameters on the plastic defo...

Since tubes have numerous industrial applications, different attempts are focused on the Severe Plastic Deformation (SPD) processes of tubes. As an illustration, Tube Channel Pressing (TCP) is an attractive process for this purpose since it can be used for processing of different sizes of tubes. However, more attempts are needed to improve the outcomes of TCP. For example, imposing of greater s...

The potential energy landscape of a flowing metallic glass is revealed using the activation-relaxation technique. For a two-dimensional Lennard-Jones system initially deformed into a steady-state condition through quasistatic shear, the distribution of activation energies is shown to contain a large fraction of low-energy barriers, consistent with a highly nonequilibrium flow state. The distrib...

The porous microstructures of metallic foams cause microscopic stress and strain localization under deformation which reduces the damage tolerance and therefore limits application of the materials. In this paper, the deformation of a relatively low porosity porous titanium is examined using two-dimensional (2D) plane strain and three-dimensional (3D) finite element models to identify the accura...