Modelling fluid flows past a body is a general problem in science and engineering. Historical sphere drag and heat transfer data are critically examined. The appropriate drag coefficient is proposed to replace the inertia type definition proposed by Newton. It is found that the appropriate drag coefficient is a desirable dimensionless parameter to describe fluid flow physical behavior so that f...

in this numerical study the the heat transfer and laminar nanofluid flow in the three-dimensional microchannels with triangular cross-section is simulated. for increase the heat transfer from the walls of the channel, semiattached & offset mid- truncated rib,s placed in the canal, and the tooth geometry and the impact is studied. in this study, the water is base fluid, and the influence of the ...

Experimental investigations of heat transfer coefficient of CuO/Water nanofluid are reported in this paper. The heat transfer coefficient of the CuO/water was measured with the help of double pipe heat exchanger. The nanofluid was prepared by dispersing a CuOnano particle in deionized water. CuO/water nanofluid with a nominal diameter of 27nm at different volume concentrations (0.1 &0.3 vol.%) ...

A numerical finite difference study has been earned out for two dimensional radiation-natural convection interaction phenomena in a vertical circular pin located at a non-participating (i.e. transparent) fluid. The coupled conservation equations in boundary layer (continuity, momentum, and energy equations) and pin energy equation are solved simultaneously using modified box method and fully im...

An experimental investigation on heat transfer coefficient is presented from three horizontal tubes in a vertical array in a duct for 500<ReD<6000. A mass transfer measuring technique based on psychrometry chart is used to determine heat transfer coefficient. The diameter of the tubes is 11 mm each spaced 40 mm apart and in-line pitch ratio varies &#10in the range 0.055<D/W<0.22. The experimen...

An experimental investigation on heat transfer coefficient is presented from three horizontal tubes in a vertical array in a duct for 500<ReD<6000. A mass transfer measuring technique based on psychrometry chart is used to determine heat transfer coefficient. The diameter of the tubes is 11 mm each spaced 40 mm apart and in-line pitch ratio varies in the range 0.055<D/W<0.22. The experimenta...

In this study, condensation heat transfer coefficients of R-410A were obtained in flattened stainless tubes made from 5.0 mm inner diameter round tubes. The test range covered saturation temperature 45 , heat flux 10 °C kW/m, mass flux 100~400 kg/ms and quality 0.2~0.8. Results showed the effect of aspect ratio on condensation heat transfer coefficient was dependent on the flow pattern. For ann...

Correlation of heat transfer coefficients for air flow through the regenerator constructed from randomly paked spheres is reported for the symmetric-balanced mode of operation. The experimental results have been correlated by the least square regression has been obtained.The present correlation has been compared with the heat transfer coefficient correlations in the literature.