Pavements consisting of water-permeable paving stone have a certain retention and storage capability for rainwater in the event of intense rain. Applied on a large surface, this results in a mitigation of flood events. Compared to an impermeable surface area, the surface flow rate decreases while groundwater regeneration increases. To date, the actual change in the third water balance parameter...

In an effort to develop methods based on integrating the subsurface to the atmospheric boundary layer to estimate evaporation, we developed a model based on the coupling of Navier-Stokes free flow and Darcy flow in porous medium. The model was tested using experimental data to study the effect of wind speed on evaporation. The model consists of the coupled equations of mass conservation for two...

We experimentally investigate the evaporation of very volatile liquid droplets (Novec 7000 Engineered Fluid) in a turbulent spray. Droplets with diameters order few micrometers are produced by spray nozzle and then injected into purpose-built enclosed dodecahedral chamber, where ambient temperature relative humidity chamber carefully controlled. observe water condensation on rapidly evaporating...

Abstract: Different thickness of Cu2S thin films were prepared by vacuum evaporation under a pressure of 10-6 torr at an evaporation rate of 3Å /sec. Cu2S has direct band gap energy and indirect band gap energy at 1.2eV and 1.8 eV respectively. This paper presents the analysis of structural and optical properties of the Cu2S thin film by X-ray diffractometer (XRD) and UV-Vis-NIR Spectrophotomet...

A numerical model is developed for the evaporating liquid meniscus in wick microstructures under saturated vapor conditions. Four different wick geometries representing common wicks used in heat pipes, viz., wire mesh, rectangular grooves, sintered wicks and vertical microwires, are modeled and compared for evaporative performance. The solid-liquid combination considered is copper-water. Steady...

evaporation of micro-liter drops from solid surfaces at room condition is mainly governed by diffusion. therefore, there should be no difference between evaporation rate of sessile and pendant drops. however, some studies indicate a difference and explain the difference using buoyancy. the objective here is to reconcile the inconsistency in the literature. for that, first, by comparing two iden...

A numerical model of the evaporating liquid meniscus under saturated vapor conditions in wick microstructures has been developed. Four different wick geometries representing the common wicks used in heat pipes, viz., wire mesh, rectangular grooves, sintered wicks and vertical microwires, are modeled and compared for evaporative performance. The solid-liquid combination considered is copper-wate...