OBJECTIVES The purpose of this study was to evaluate the effect of hot pressing on the shear bond strength of a Au-Pt-Pd alloy-porcelain composite. METHODS Several metal-porcelain composites specimens were produced by two different routes: conventional porcelain fused to metal (PFM) and hot pressing. In the latter case, porcelain was hot pressed onto a polished surface (PPPS) as well as a rou...

The repaired denture base material fractures at the interface of base and repair material. This study evaluated the effect of different chemical treatment of the surfaces on the shear bond strength of conventional heat-cured resin repaired with autopolymerized acrylic resin. The specimens were divided into four groups, 30 specimens each according to surface treatment by chemical etchants Group ...

background: the aim of this study was to compare the shear bond strength of four one-step self-etch adhesives with different ph values to enamel and dentin. materials and methods: in this in vitro study, 200 bovine permanent mandibular incisors were used. four one-step self-etch adhesives with different ph values were tested both on enamel and on dentin: adper™ easy bond self-etch adhesive (ph ...

This study presents a new mechanical tube cladding process named punch plastic deformation pipe cladding (PPDPC) based on local deformation by pressing a punch into the inner layer of the bimetal tube. To investigate the capability of the process, stainless steel tube (as the inner layer) is bonded to a carbon steel pipe (as the outer layer) to fabricate a bimetal pipe. Shear punch tests were u...

The in vitro shear and tensile strength of four enamel adhesives was investigated. The materials examined were System 1+, Vitrebond, C & B Metabond and Panavia-Ex (original version). The mode of failure of each material was also investigated under a scanning electron microscope. Edgewise mesh-backed brackets were bonded to the buccal surface of extracted premolar teeth and forces applied with a...

the mechanical behaviour of rockfill materials and aggregates depends not only on particle size and compaction, but also on their strength and lithological properties. in this research two types of large triaxial and direct shear tests are performed on rockfill materials. this paper compares the stress-strain behaviour of sandstone and andesibasalt materials in triaxial compression tests (3006...

This paper summarizes a series of studies on the interface of fiber reinforced polymer laminates externally bonded to concrete substrates, carried out in the Laboratory of Engineering for Maintenance Systems, Hokkaido University. Appropriate test methods and bond models for shear bond, tensile bond and cleavage bond (bond under dowel force) are shown. Finally, experimental results on shear bond...

With the recent development of 3D printing technology, concrete materials are sometimes used in 3D printing. Concrete structures based on 3D printing have been characterized to have the form of multiple layer build-up. Unlike general concrete structures, therefore, the 3D-printed concrete can be regarded as an orthotropic material. The material property of the 3D-printed concrete’s interface be...

Timo Heikkinen. Bonding of Composite Resin to Alumina and Zirconia Ceramics with Special Emphasis on Surface Conditioning and Use of Coupling Agents. Department of Biomaterials Science, Institute of Dentistry, University of Turku. Annales Universitatis Turkuensis, Turku, Finland 2011. Dental oxide ceramics have been inspired by their biocompability and mechanical properties which have made dura...