In order to gain a better understanding of the formation of plessite in iron meteorites, various electron optical techniques were employed to study the range of plessite structures observed in the Carlton fine octahedrite. Compositional and structural studies of twins in clear taenite and the cloudy zone were made. Transmission electron microscopy studies of martensitic and duplex a + y plessit...

The damping characteristics of Ti50Ni50-xCux (x = 0~30 at.%) shape memory alloys (SMAs) at a low frequency have been studied using a dynamic mechanical analyzer. The magnitude of the tan δ value and the values of the storage modulus (E₀) softening/hardening and the strain variation exhibited in B2↔B19 transformation are all higher than those in B2↔B19' transformation. The larger E₀ softening/ha...

The microstructure and properties of a 5 wt.% Cr cold work tool steel were studied after austenitisation at 1020°C, 1050°C or 1075°C followed by single, double and triple tempering treatments at 525°C. The microstructures were investigated with scanning electron microscopy and X-ray diffraction and phase transformations were studied by dilatometry. Furthermore, hardness and Charpy un-notched an...

austenite is a semi-stable phase in most stainless steels that deforms to martensite under md30 and forms martensitetype ά and ε due to the deformation in the steels. since the distribution of strain induced martensite plays animportant role in achieving desired properties, the main objective of the present work is to model martensitedistribution of ά during cold rolling using finite element me...

In this study the α′′ stress-induced martensitic transformation and damping behaviour of the superelastic β-Ti–25Ta–25Nb alloy are investigated by tensile tests at room temperature and by dynamic mechanical analysis (DMA) in tensile mode for different applied stresses. Tensile tests show a fully non-linear elastic domain and, consequently, a specific method is proposed to determine the elastic ...

The quantitative characterization of the microstructure evolution in high-Mn steel during deformation is of great importance to understanding its strain-hardening behavior. In the current study, in situ high-energy synchrotron X-ray diffraction was employed to characterize the microstructure evolution in a Fe-17Mn-1.5Al-0.3C steel during a tensile test. The microstructure at different engineeri...

The origin of the martensitic transition in the magnetic shape memory alloy Ni-Mn-Ga has been widely discussed. While several studies suggest it is electronically driven, the adaptive martensite model reproduced the peculiar nonharmonic lattice modulation. We used femtosecond spectroscopy to probe the temperature and doping dependence of collective modes, and scanning tunneling microscopy revea...

Austenite is a semi-stable phase in most stainless steels that deforms to martensite under Md30 and forms martensitetype ά and ε due to the deformation in the steels. Since the distribution of strain induced martensite plays animportant role in achieving desired properties, the main objective of the present work is to model martensitedistribution of ά during cold rolling using...

This work is to the best of my knowledge original, except where acknowledgements and references are made to previous work. Neither this, nor any substantially similar dissertation has been or is being submitted for any other degree, diploma or other qualification at any other university. This dissertation does not exceed 60,000 words in length. Abstract iii DFT Pak, Jun Hak 20080959 Coalesced s...

Martensitic transformation associated with a tensile deformation of CuAlMn single crystals in [loo] direction was studied using in-situ transmission electron microscopy. Stress/strain curves obtained during pseudoelastic deformation of microscopic samples were slightly different fiom bulk ones due to martensite formation in the stage of stress increase and a permanent deformation during the fir...