Chemical and physical transformations by milling are attracting enormous interest for their ability to access new materials and clean reactivity, and are central to a number of core industries, from mineral processing to pharmaceutical manufacturing. While continuous mechanical stress during milling is thought to create an environment supporting nonconventional reactivity and exotic intermediat...

A solid state synthesis of calcium manganite (CaMnO3) is described where equimolecular mixtures CaCO3:MnCO3 have been subjected to mechanical stress (high energy milling) so yielding CaCO3-MnCO3 solid solutions of nanometric particle size. TG measurements have shown that a link exists between milling time, the extent of non-stoichiometry and the milling-induced decomposition of MnCO3 to Mn3O4. ...

Mechanical alloying (MA) is a solid-state powder processing technique involving repeated cold welding and fracturing of powder particles in a high-energy ball mill. It has been used to obtain nanocrystalline binary system FeNi. Fe and Ni elemental powders have been ball milled in a planetary mill (Pulverisette5, Fritsch) for various times up to several hours. The morphology of the powders was e...

Mechanical alloying of Ti-Si and NiTi was performed by high-energy ball milling at ambient temperature. The structural and compositional evolutions during mechanical alloying were investigated. Results showed that the crystallite size of mechanically alloyed Ti-Si and Ni-Ti powders decreased with increasing milling time and the steady-state crystallite size was approximately 10 nm. The mechanic...

in this research, mechanical alloying was used to produce ti-50al, ti-45al-5cr and ti-45al-5w (at%) alloys. the effect of ternary addition (cr and w) on microstructure and production efficiency of tial alloy were investigated. alloying was performed in a planetary mill and the milling time varying from 5 to 70h. the structural evaluation in these powders was done by x-ray diffraction (xrd) tech...

An attachable electromagnetic-energy-harvester driven wireless vibration-sensing system for monitoring milling-processes and cutter-wear/breakage-conditions is demonstrated. The system includes an electromagnetic energy harvester, three single-axis Micro Electro-Mechanical Systems (MEMS) accelerometers, a wireless chip module, and corresponding circuits. The harvester consisting of magnets with...

Realgar is a poorly water-soluble compound that exhibits poor bioavailability. To improve this, the authors reduced the particle size of realgar to nanoscale by high-energy ball milling and optimized the preparation process under which (realgar weight 40 g, milling time 9 hours, milling speed 38 Hz, milling temperature -20°C) realgar nanoparticles (NPs) with an average size of 78 ± 8.3 nm were ...

RATIONALE Milling of wood samples is a widely applied preparation method for pooling tree-rings from different trees or periods of several years for determination of δ(13)C and δ(18)O values. In this study, whole wood samples were milled using different procedures in order to evaluate potential effects of this preparation method on δ(13)C and δ(18)O values. METHODS Subsamples of a 5 cm(3) woo...

A prototype of a haptic and virtual reality simulator has been developed for simulation of the bone milling and material removal process occurring in several operations, e.g. temporal bone surgery or dental milling. The milling phase of an operation is difficult, safety critical and very time consuming. Reduction of operation time by only a few percent would in the long run save society large e...