In Direct Metal Laser Sintering objects are created by sequential sintering loose metal powder particles by means of laser technology. When the laser sintering process involves temperature gradients, thermal stresses develop. Corresponding residual stresses induce warping of the densified structure leading to unacceptable tolerance losses. This paper examines the role of laser beam scan pattern...

A postsurgical upper complete denture was constructed with metal press-plate specially improved for applying the acrylic resin containing 4-META in the hemimaxillary edentulous patient. The whole process of denture construction is described and the resultant denture effect is evaluated by our test method in this paper. The main findings are: 1. The internal surface is quite smooth and clean 2. ...

This case report describes a simple method for identifying the citizenship of a denture wearer by marking the telephone country code number inside the denture base. A wax pattern for the denture framework was prepared on the refractory cast. A piece of embossing tape, containing the country code (81, Japan), Japanese prefectural code, and abbreviation of the dental clinic where the denture was ...

We consider detailed roughness and conductivity corrections to the Casimir force in the recent Casimir force measurement employing an atomic force microscope. The roughness of the test bodies — a metal plate and a sphere — was investigated with the AFM and the SEM respectively. It consists of separate crystals of different heights and a stochastic background. The amplitude of roughness relative...

Introduction: The techniques used to fixate osteotomized segments of bone have evolved alongside the treatment of craniosynostosis. The use of nonresorbable metal plates and screws offered a method of rigidly stabilizing repositioned segments of bone. Several reports specify the tendency for these fixation systems to "migrate" transcranially. Methods: We present a unique case of a patient who i...

In the present study plate-impact pressure-shear friction experiments are conducted to study dynamics of high-speed slip at metal-on-metal interfaces. By using a CH tool-steel/Ti–6Al–4V tribo-pair and appropriate selection of the flyer and target plate thicknesses, the experiment has been used to investigate the frictional resistance of sliding interfaces subjected to step changes in slip rates...

The Bremsstrahlung spectrum from a 6-MV linear accelerator (LINAC) was obtained and used as an input X-ray source in the simulation to estimate several important physical quantities of the detector in a therapeutic X-ray portal imaging system, such as quantum and energy absorption efficiencies, Swank factor, and detective quantum efficiency (DQE). In addition, we have obtained a spatial distrib...

A new eddy-current system based on low-noise magnetoresistive sensors has been developed to detect cracks and corrosion in thick, multi-layer metal structures. The new instrument has detected narrow slots as short as 6.3 mm, in the lowest layer of a stack of three aluminum plates totaling 25 mm in thickness. These flaws were detected through 19 mm of overlying aluminum, in spite of the presence...

Current bone repair implants for use within the body are made from metals [1, 2], which have disadvantages such as stress shielding and can remain in the body permanently. In addition, a fractured bone fixated with a metal plate may re-fracture upon removal of the implant [3].This is due to the fact that bone does not carry sufficient load during the healing process. Recently, a move towards de...

Bipolar plate is one of the key components of proton exchange membrane fuel cells (PEMFC). Since the production costs of traditional graphite bipolar plates are very expensive and need a few millimeters thickness over the space, the resulting metal bipolar plate not only reduces the cost of such a bipolar plate, the thickness can also be reduced to micron range. This study aims to explore the a...