This application note describes the LED driving system using a half-bridge LLC resonant converter for high power LED lighting applications, such as outdoor or street lighting. Due to the existence of the non-isolation DC-DC converter to control the LED current and the light intensity, the conventional PWM DC-DC converter has the problem of low-power conversion efficiency. The halfbridge LLC con...

This paper describes the implementation of the image rejection mixer block in the 5GHz frequency band using 0.18μm CMOS technology. The image rejection mixer block adopts the double-quadrature topology for high image-rejection ratio in the high frequency applications and is designed for the dual-conversion receiver. The loss of the polyphase filter in the signal path can be reduced with simple ...

The Axion Dark Matter eXperiment (ADMX) was designed to detect ultra-weakly interacting relic axion particles by searching for their conversion to microwave photons in a resonant cavity positioned in a strong magnetic field. Given the extremely low expected axion–photon conversion power we have designed, built and operated a microwave receiver based on a Superconducting QUantum Interference Dev...

A new application of the three-phase buck-resonant converter is presented in this paper. It is shown that the analyzed converter is suitable to operate as the rectifier stage in low power wind energy conversion systems (WECS) based on permanent magnet synchronous generators (PMSG) with variable wind speed. As main features, it presents a single controlled switch, simple implementation and contr...

Extra Ordinary (X) mode conversion to Bernstein wave near Upper Hybrid Resonance (UHR) layer plays an important role in plasma heating through cyclotron resonance. Wave generation at UHR and parametric decay at high power has been observed during Electron Cyclotron Resonance (ECR) heating experiments in toroidal magnetic fusion devices. A small linear system with ECR and UHR layer within the sy...

This paper analyses two schemes of single-stage diode-switched active filters used in new switching power supplies designs to improve the power factor. From the point of view of the power flow, the distortion reduction is based on the improvement of the power conversion processes. Most of the ca/cc switching power supplies consists of two separated parts: a rectifier – in most cases a diode bri...

one of the main problems in wind energy conversion system (wecs) is how to achieve maxim­u­m output power in different wind speeds. maximum methods for maximum power point tracking in wind energy conversion syst­e­ms require the knowledge of system characteristics and mechanic sensors. so, using these methods practically will follow with high price and an abundant difficulties. in this paper, n...

typically, two configurations are used for energy harvesting, with different advantages: piezoelastic and piezomagnetoelastic. best performance of piezoelastic configuration is limited to its narrow bandwidth around the resonance frequency. if the excitation frequency slightly deviates from the resonance frequency, the power-out is severely reduced. to overcome this, the piezomagnetoelastic has...

This paper presents and implements a single-stage high-power-factor light-emitting diode (LED) driver with coupled inductors, suitable for streetlight applications. The presented LED driver integrates an interleaved buck-boost power factor correction (PFC) converter with coupled inductors and a half-bridge-type series-resonant converter cascaded with a full-bridge rectifier into a single-stage ...