Rocket fairings, load-carrying structures of solid rocket motor case, e.g., inter-stage joint, satellite-rocket joint, etc., usually take the shape of conical shell sections. This paper is to evaluate spatially distributed microscopic control characteristics of distributed actuator patches bonded on conical shell surfaces. The converse effect of piezoelectric materials has been recognized as on...

Little has been written about the structural behavior of conical shells, while conical shells’ construction techniques due to the high rise and small span has always required special attention throughout the history of Islamic architecture. This paper aims to examine how conical shells bear weight loads and resist against bending through a qualitative analysis. After proving that ‘r...

A truncated conical beam model is developed to study the vibration behaviour of a rat whisker. Translational and rotational springs are introduced to better represent the constraint conditions at the base of the whiskers in a living rat. Dimensional analysis shows that the natural frequency of a truncated conical beam with generic spring constraints at its ends is inversely proportional to the ...

We demonstrate the synthesis of near-IR-emitting zinc blende CdTe/CdS tetrahedral-shaped nanocrystals with a magic-sized (approximately 0.8 nm radius) CdTe core and a thick CdS shell (up to 5 nm). These high-quality water-soluble nanocrystals were obtained by a simple but reliable aqueous method at low temperature. During the growth of the shell over the magic core, the core/shell nanocrystals ...

We present kinematic measurements of the thick and thin disks in two edge-on galaxies. We have derived stellar rotation curves at and above the galaxies’ midplanes using Ca ii triplet features measured with the GMOS spectrograph on Gemini North. In one galaxy, FGC 1415, the kinematics above the plane show clear rotation that lags that of the midplane by ∼20-50%, similar to the behavior seen in ...

The present work concerns the forming of the sheet metal conical products which, combined with a vulcanized rubber blend form footings for electric power generators. Conical sheet metal elements are most often formed by the following four methods: – multi-operational stamping with stiff tools, – hydro-mechanical stamping, – spinning, – flow turning. In case of stiff tool stamping, traces on the...