INTRODUCTION The Externally Fired Combined Cycle (EFCC) is an advanced coal-fired power generation concept with a potential for higher thermal efficiency and lower cost than conventional coal-based systems. 1 The concept incorporates efficient gas turbine combined cycle technology for use with coal. Unlike "direct fired" combined cycles, the EFCC does not require any special fuel preparation. T...

Shell and Tube heat exchangers are the heat exchangers that are most widely used in industries and for other commercial purposes. There are many techniques that have been utilized to enhance the heat transfer performance of the shell and tube heat exchangers. Air bubble injection is one of the promising and inexpensive techniques that can create turbulence in the fluids resulting in to enhancem...

Measurements of three-dimensional turbulent flow in the exit head section of a shell-andtube heat exchanger were performed using three-component laser Doppler velocimeter. The test geometry is half of a hemispherical cap with two outlet-tubes and with a cylindrical inlet section. Distributions of the velocity vector field, the three mean velocity components, and the Reynolds stress components a...

Heat exchangers are used to transferring energy (heat), using fluids or gases, both hot and cold, from one area another due temperature differences. Almost all agricultural wastes serve as carbon products which essential produce graphene oxide, it is very possible get oxide by synthesizing waste expected reduce the amount of on earth. After carrying out synthesis, necessary test characterizatio...

Leakage in heat exchanger tubes can result in unreliable products and dangerous situations, which could cause great economic losses. Along with fast development of modern acoustic detection technology, using acoustic signals to detect leakage in heat exchange tube has been gradually accepted and considered with great potential by both industrial and research societies. In order to further advan...

This paper presents a simple methodology for cost estimation of a near optimal heat exchanger network, which comprises mixed materials of construction. Intraditional pinch technology and mathematical programming it is usually assumed that all heat exchangers in a network obey a single cost model. This implies that all heat exchangers  in a network are of the same type and use the same mate...

Leakage in heat exchanger tubes can result in unreliable products and dangerous situations, which could cause great economic losses. Along with fast development of modern acoustic detection technology, using acoustic signals to detect leakage in heat exchange tube has been gradually accepted and considered with great potential by both industrial and research societies. In order to further advan...

The effect of γ-Al2O3 nanoparticles on heat transfer rate, baffle spacing and pressure drop in the shell side of small shell and tube heat exchangers was investigated numerically under turbulent regime. γ-Al2O3-water nanofluids and pure water were used in the shell side and the tube side of heat exchangers, respectively. Since the properties of γ-Al2O3-water nanofluids were variable, they were ...

The focus of this work is the modeling and performance comparison of different models of pulse tube refrigerators, namely, the Orifice Pulse Tube Refrigerator (OPTR) and the Inertancetube Pulse Tube Refrigerator (IPTR) with both in-line as well as coaxial configurations. A detailed analysis of the flow and heat transfer in various components of the above mentioned models under oscillating flow ...