This study represents a year-round energy performance of two solar water heating (SWH) systems with a 4m2 flat plate collector (FPC) and an evacuated tube collector (ETC) operating under the same weather conditions. The energy performance of the two considered systems was compared on a monthly and yearly basis. The obtained results showed that for an annual total solar insolation of ...

This study is concerned with the results of a Life Cycle Assessment comparison between photovoltaic e silicon based modules and thin film modules e and solar thermal systems, as technologies which are usually installed for partially covering household energy demand. Several studies focused on energy and environmental performances of photovoltaic and solar thermal collectors, however they have b...

The amine regenerator of acid removal unit in South Pars Gas Complex, Assalouyeh, Iran was modeled. This model was fitted to assess the large scale columns and allow application of solar thermal energy for production of low pressure steam. Heat transfer fluids including Therminol oil, sulfur, or salt melt could be applied to yield thermal energy from a solar collector and to store and transfer ...

In this work, the potential of magnetron sputtered magnesium uoride (MgF2) and MgF2 containing composite coatings for coloured solar collector glazing is investigated. Coloured thinlm interference coatings on the reverse side of the collector cover glass give solar collectors an aesthetic appearance, which facilitates their integration into the building’s envelope. Hereby, integration means tha...

The objectif of the present work is to determinate the potential of the solar parabolic trough collector (PTC) for use in the design of a solar thermal power plant in Algeria. The study is based on a mathematical modeling of the PTC. Heat balance has been established respectively on the heat transfer fluid (HTF), the absorber tube and the glass envelop using the principle of energy conservation...

introduction electrical performance of solar cells decreases with increasing cell temperature, basically because of growth of the internal charge carrier recombination rates, caused by increased carrier concentrations. hybrid photovoltaic/thermal (pvt) systems produce electrical and thermal energy simultaneously. pvt solar collectors convert the heat generated in the solar cells to low temperat...

Relative to solar water heaters, solar air heaters have received relatively little investigation and have resulted in few commercial products. However, in the context of a humidification-dehumidification (HDH) desalination cycle, air heating accounts for advantages in cycle performance. Solar collectors can be over 40% of an air-heated HDH system’s cost; thus, design optimization is crucial. Be...

In this paper, artificial neural networks (ANNs) and genetic algorithms (GAs) are used for the design of solar flat-plate collectors. It is proved in this paper that by using the Taguchi method for selecting the data required for training the ANN is very effective in allowing the network to learn the behavior of the system satisfactorily. The parameters on which the flat-plate collector design ...

Saleh, Ahmad M. M.S.E., Purdue University, May 2012. Modeling Of Flat-Plate Solar Collector Operation in Transient States. Major Professor: Hosni Abu-Mulaweh. Solar energy is becoming an alternative for the limited fossil fuel resources. One of the simplest and most direct applications of this energy is the conversion of solar radiation into heat, which can be used in water heating systems. A c...