The purpose of this research paper is to study the tool wear and surface roughness of AISI 8620 material using coated ceramic tool by turning process. Ceramic cutting tools have outstanding material hardness, resistance to high temperatures, wear resistance, chemical stability and hot hardness. Ceramic tool with Al2O3 + TiC (golden) coating was used to investigate the surface roughness and tool...

INTRODUCTION Optimization of machining parameters is essential for improving expected outcome of any machining operation. CASE DESCRIPTION The aim of this work is to find out optimum values of machining parameters to achieve minimal surface roughness during milling operation of GFRP. DISCUSSION AND EVALUATION In this machining operation speed, depth of cut and feed rate are considered as pa...

The nanomechanical characteristics of polycarbonate (PC) polymer were investigated by atomic force microscope (AFM) and nanoindentation. Scratching, wear properties, hardness and Young’s modulus were obtained. The relationships between scribing feed and speed, surface depth and roughness and applied load were also investigated. The results indicated that as the applied load was increased, the f...

Controlling the process variations on the perimeter of a component to the targeted mean in milling is a huge challenge. Several factors such as spindle speed, feed rate, depth of cut, etc. affects this process variation. In this paper, spindle speed and feed rate are considered. Aluminum alloy 6061 widely used materials in aircraft, automobile and helicopter components is selected for this stud...

A high strength nickel chromium alloy (50Cr-50Ni-Nb alloy), commonly referred to as IN-657, is specifically used for components in furnaces which are fired by low grade fuel oils containing high levels of vanadium, sodium and sulphur. The purpose of this study is to experimentally investigatethe effect of machining parameters on machinability in turning of Inconel 657. The considered parameters...

In turning process, engineers are often faced with the problems of relating the cutting parameters (Speed, feed, depth of cut) to the output responses(Feed force, Thrust force, Cutting force, Surface roughness) to optimize the process. Also, Turing is done with the aim of achieving the best surface finish. But without optimization, it is not possible to automate the process. Turning process inv...

a high strength nickel chromium alloy (50cr-50ni-nb alloy), commonly referred to as in-657, is specifically used for components in furnaces which are fired by low grade fuel oils containing high levels of vanadium, sodium and sulphur. the purpose of this study is to experimentally investigatethe effect of machining parameters on machinability in turning of inconel 657. the considered parameters...

This paper presented a new grinding method in relation to the focus of high-speed precision machining for non-circular parts. We designed and integrated a set of grinder NC system, refitted an experimental NC grinder and researched into the control core of the NC grinder-open Programmable Multi-Axis Controller (PMAC), linear motor feed unit and high-speed electrical spindle unit. The numerical ...