In modern research, development of monomers that reduce shrinkage of composite materials remains an ongoing quest and perennial challenge. The purpose of this study, therefore, was to analyze the shrinkage behaviour of an innovative composite material for dental restorations based on a monomer with a new chemical formulation, known as silorane. To this end, shrinkage stress development during c...

This paper reports the results of an experimental work conducted to investigate the effect of curing conditions on the compressive strength of self-compacting geopolymer concrete prepared by using fly ash as base material and combination of sodium hydroxide and sodium silicate as alkaline activator. The experiments were conducted by varying the curing time and curing temperature in the range of...

The present study aimed to assess the influence of curing distance on the loss of irradiance and power density of four curing light devices. The behavior in terms of power density of four different dental curing devices was analyzed (Valo, Elipar 2, Radii-Cal, and Optilux-401) using three different distances of photopolymerization (0 mm, 4 mm, and 8 mm). All devices had their power density meas...

This study evaluated the bond strength (push-out method) and Knoop hardness of Z250 composite resin, photoactivated with XL 2500 curing unit, using different protocols: continuous mode (700 mW/cm(2) for 20s) (CO); soft-start (50 mW/cm(2) for 5 s, followed by 700 mW/cm(2) for 15 s) (SS1); soft-start (100 mW/cm(2) for 5 s, followed by 700 mW/cm(2) for 15 s) (SS2); soft-start (150 mW/cm(2) for 5 s...

Inadequate intensity of the polymerization light source can compromise the quality and longevity of dental composite restorations. In order to maintain optimal strength of polymerization devices, regular control of polymerization units is necessary. The aim of this study was to compare the accuracy of two radiometers in the measurement of light intensity of photopolymerization devices concernin...

AIM The aim of this study was to investigate the effect of different incremental insertion techniques, photoactivation, and restorative phases on thermal variations occurring during the polymerization of Filtek Z250 composite resin. METHODS AND MATERIALS The experiment was conducted using 90 bovine incisor teeth. The teeth were randomly assigned to three groups according to the technique used...

The aim of this study was to evaluate the polymerization stress and degree of conversion of a composite submitted to different photoactivation protocols. The composite Filtek Z350 was placed in the central perforation of a photoelastic disc and polymerized using a LED-based curing unit (BluePhase II--Ivoclar Vivadent) with energy density of 12, 24 or 36 J/cm2 using the following photopolymeriza...

PURPOSE The aim was to evaluate the effect of curing mode and different dentin surface pretreatment on microtensile bond strength (µTBS) of self-adhesive resin cements. MATERIALS AND METHODS Thirty-six extracted human permanent molars were sectioned horizontally exposing flat dentin surface. The teeth were divided into 12 groups (3 teeth/group) according to the dentin surface pretreatment met...

OBJECTIVE To test the hypothesis that bonding with a blue light-emitting diode (LED) curing unit produces no more failures in adhesive-precoated (APC) orthodontic brackets than bonding carried out by a conventional halogen lamp. MATERIALS AND METHODS Sixty-five patients were selected for this randomized clinical trial, in which a total of 1152 stainless steel APC brackets were employed. In or...