—In this paper, we investigate the robust transceiver design for Multi-Input Multi-Output (MIMO) Interference Channel (IC) networks with imperfect Channel State Information (CSI). With the assumption of Gaussian CSI uncertainty, a probabilistic constraint robust transceiver design problem is formulated by maximizing the average received signal while constraining the probability of large interf...

The DMT transceivers have enjoyed great success in high speed data transmission. The DMT scheme is realized by a transceiver that divides the frequency selective channel into a set of frequency nonselective parallel subchannels. The efficiency of the scheme depends on the frequency selectivity of the transmitting and receiving filters. In the past, the filterbank transceiver has been proposed a...

The Serial Streaming Telemetry infrastructure is being augmented with the Telemetry Network System, which is a net-centric infrastructure requiring bi-directional communications between the test article segment and the ground station segment. As a result, future radio segments must implement transceiver architecture to support bi-directional communications. This paper presents a design methodol...

Continued demand for higher bandwidth in data networks along with an industry need for standardized network components has driven the need for 10 Gb/s optical transceivers into the long haul, metro core, and enterprise/storage environments. In response to this demand, the functionality and performance of these modules have increased significantly, while the size, cost, and power consumption hav...

Synthetic Aperture Radar (SAR) imaging is an expensive endeavor. It can be difficult for universities, small business, or individuals to experiment with SAR imaging and algorithm development on a low budget. For this reason, a uniquely inexpensive solution to FrequencyModulated Continuous-Wave (FMCW) radar was developed and then utilized as an ultra low cost SAR imaging system. This unique appr...

1. Introduction Recently, a multi-standard transceiver has started to attract more attention with the overwhelming increase of various wireless standards that covers different frequency bands and uses diverse modulation standards. Moreover, the realization of a single chip that covers all the standards is desired for low-cost and downsizing. For this reason, a power amplifier that can tune the ...

A novel Uniform Discrete Multitone (DMT) transceiver is proposed, utilizing a wavelet packet based filter bank transmultiplexer in conjunction with a DMT transceiver. The proposed transceiver decomposes the channel spectrum into subbands of equal bandwidth. The objective is to minimize the bit error rate (BER), which is increased by channel‐noise amplification. This noise amplification is due t...

JOSEPH, BALU High-Speed Transceiver Design in CMOS using Multilevel (4-PAM) Signaling. (Under the direction of Dr. Wentai Liu) The design of a 4 Gbps serial link transceiver in 0.35μm CMOS process is presented. The major factors limiting the performance of high-speed links are transmission channel bandwidth, timing uncertainty and on-chip frequency limitations. The design uses a combination of ...

ZigBee technology was developed for special wireless networks where Bluetooth & wi-fi technologies are not showing better results. In wireless personal area networks (PAN) where we need to transmit low data rate information in comparatively large area (10-100 m). We can use Zigbee transceiver system instead of other technologies. As the functionality of Simplicity and Zigbee Technology is simil...

This paper presents a low-power single chip WLAN 802.11a transceiver RFIC for personal communication terminal applications. The 5.2GHz transceiver RFIC is implemented in a 0.5 m SiGe technology with 16 mm die size. It consumes 110/130mA in receive/transmit mode under a 3.3V supply. The receiver path shows a 6.4dB noise figure and a -20dBm IIP3 under a maximal 67dB gain. The transmitter path OIP...