In the sensing applications of optical fiber grating, it is necessary to reduce the transmission-type polarization dependence to isolate the sensing parameter. It is experimentally shown that the polarization-dependent spectrum of acousto-optic long-period fiber grating sensors can be suppressed in the transmission port of a π-shifted Sagnac loop interferometer. General expressions for the tran...

We report spectral splitting behaviors based on Fano resonances in a novel simple planar metasurface composed of gold nanobars and nanorings. Multiple plasmonic modes and sharp Fano effects are achieved in a broadband transmittance spectrum by exploiting the rotational symmetry of the metasurface. The transmission properties are effectively modified and tuned by modulating the structural parame...

An experimental setup and procedure for accurate transmittance measurements of candidate filters for the Auger Fluorescence Detector is presented. For this check, we used the Hitachi U-2000 double-beam spectrophotometer (Sph) of the Chemical Department of the University of Athens (UoA). After the calibration of the Sph, we are able to observe transmittance deviations over the area of the filter...

In this paper the transmittance of metal-insulator-metal (MIM) waveguides containing semi-circular ring shaped and rectangular ring shaped grooves are investigated. By varying groove parameters their effects on the transmittance of the MIM waveguides are investigated. The results show that the transmittance spectra of the waveguides have maximum and minimum points, and by using appropriate para...

Transmittance spectra of fungi were estimated from seven-band optical micrographs. An optical microscope adjusted with a single-chip CCD camera with seven band filters was used for image acquisition. The Wiener method was applied to estimate the transmittance spectra of five species that belong to one genus of fungi. The Wiener estimation operator was calculated from transmittance spectra of 16...

various concentrations of copper were embedded into silica matrix to xerogel forms using copper source cu(no3)2∙3h2o. the xerogel samples were prepared by hydrolysis and condensation of tetraethyl ortho-silicate (teos) with determination of new molar ratio of the components by the sol-gel method. after ambient drying, the xerogel samples were heated from 60 to 1000˚c at a slow heating rate (50°...

Optical glasses are optimized to provide excellent transmittance throughout the total visible range from 400 to 800 nm. Usually the transmittance range spreads also into the near UV and IR regions. As a general trend lowest refractive index glasses show high transmittance far down to short wavelengths in the UV. Going to higher index glasses the UV absorption edge moves closer to the visible ra...

Abstract The efficiency of both solar photovoltaic and thermal power generation is relatively low, with the maximum panel temperature conventional PV/T modules reaching 68.4 °C at noon, average electrical only 12.98%. In this paper, energy performance a module based on SiO 2 nanofluid was studied. Firstly, three different types nanofluids, mass fraction 0.3%, 0.5%, 0.7%, were prepared tested fo...

This study is an initial investigation on the capability of multispectral imaging to capture subtle spectral information that would enable the automatic delineation between the eosinophilic esophagitis and other eosin stained tissue components, especially the RBCs. In the method, a principal component analysis (PCA) was performed on the spectral transmittance samples of the different tissue com...

Most existing techniques for regulating the ink flow in offset presses rely on density measurements carried out on specially printed patches. In the present contribution, we develop a methodology to deduce ink thickness variations from spectral measurements of multi-chromatic halftone patches located within the printed page. For this purpose, we extend the Clapper-Yule spectral reflectance pred...