Polymer nanocomposites operate in applications where fluid and grease lubricants fail, and have superior tribological performance to traditional polymer composites. Nanoparticle fillers have been a part of notable reductions in the wear rate of the polymer matrix at very low loadings. Despite instances of remarkable wear reductions at unprecedented loadings (3 000 times at 0.5% loading in one c...

In this paper we investigate the tribological properties of AlSn-based alloy with different amount of graphite at different normal loads and sliding speed. A modified impeller mixing coupled with chill casting technique was used for the preparation of immiscible alloys. In this paper Al-Sn binary alloys was chosen for this study. This binary system shows the miscibility gap at different concent...

The correlation between the mechanical properties of Fillers/Epoxy composites and their tribological behavior was investigated. Tensile, hardness, wear, and friction tests were conducted for Neat Epoxy (NE), Graphite/Epoxy composites (GE), and Data Palm Fiber/Epoxy with or without Graphite composites (GFE and FE). The correlation was made between the tensile strength, the modulus of elasticity,...

A series of novel green lubricants with dissolved lignin in [choline][amino acid] ([CH][AA]) ionic liquids (ILs) have been synthesized in this work. The effect of lignin on the thermal and tribological properties of the lignin/[CH][AA] lubricants was systematically investigated by means of thermogravimetric analysis, differential scanning calorimetry, and a friction and wear tester. The lignin ...

The tribological protection of carbon fiber reinforced epoxy composites (CFC) is essential for broadening their use from structural to functional applications, e.g., to linear bearings in mechanical engineering. However, their wear resistance in sliding and rolling contacts is low. This work focusses on the possibility of improving their tribological properties by the application of thin hard m...

The fundamental processes of tribology related to friction, wear, and adhesion [1–3] are still not well understood [4,5]. When a single asperity touches and slides on a surface, complex phenomena such as local rearrangements of atoms, permanent change of the surface structure [6], and more macroscopic phenomena such as dislocation motion or microstructural changes can occur. As the interface is...

Abstract: Austenitic stainless steels exhibit a low hardness and weak tribological properties. The wear behaviour of austenitic stainless steel AISI 316 was evaluated through the pin on disc tribological method. For investigating the effect of wear on the changes in microstructure and resistance to wear, optical microscopy and scanning electron microscope were used. The hardness of the worn...

In this work, real-time coefficient of friction (COF) analysis, in conjunction with a new method for approximating the Sommerfeld Number, is used to determine the extent of normal and shear forces during chemical mechanical planarization (CMP) and to help identify the tribology of the system. A new parameter termed the ‘tribological mechanism indicator’ is defined and extracted from the resulti...

Conductive carbon films were prepared at room temperature by unbalanced magnetron sputtering (UBMS) on silicon substrates using argon (Ar) gas, and the effects of post-annealing temperature on the structural, tribological, and electrical properties of carbon films were investigated. Films were annealed at temperatures ranging from 400 °C to 700 °C in increments of 100 °C using a rapid thermal a...

Nanocomposite thin film coatings of MoS2-added CrN/TiAlN tribological multilayers were prepared by reactive co-sputtering of Ti/Al 50/50 at.%, pure chromium and MoS2 targets of the independently d.c. driven unbalanced magnetrons. Nano-scaled tri-layer system with periodic thickness in a range of 4-10 nm of CrN, TiAlN and MoS2 compound layer with a broad interface, in which the composition is co...