Cross-linked polyethylene has been explored as an alternative to conventional polyethylene in total joint replacement in order to reduce wear volume and decrease failure through polyethylene wear debris induced osteolysis [1]. Due to the demands of a total knee replacement, moderately cross-linked polyethylene is recommended to retain mechanical properties [2]. This study aims to investigate th...

-Hardfacing is one of the most useful and economic ways to improve the performance of components submitted to severe wear conditions. A study was made to compare the microstructure and abrasion resistance of hardfacing alloys reinforced with primary chromium carbides, the hardfacing alloys were deposited onto M.S. plate by SMAW process. Two different commercial hardfacing electrodes were employ...

In this research, B4C-Ni cermet coating was sprayed on the surface of 4130 steel from B4C and Ni feed-stockpowders using high velocity oxy-fuel (HVOF) method. In order to characterize the tribological behavior of thecoating, ball on disk wear tests were done at the ambient temperature and under the loads of 1, 3 and 5 N.Phase analysis of the coating after spraying was studied ...

In this paper, the metal matrix composites containing 22 wt % Cr, 2.5 wt % C and 2 to 16  volume percent TiC were processed by solidifying Fe-Cr-Ti-C in which precipitation of titaniumcarbide and chromium carbide occurred. The microstructure and abrasion resistance of in-situ synthesized composites were compared with the unreinforced high chromium white cast iron (HCWCI) containing 22 w. t. % C...

accumulative roll bonding (arb) was used to fabricate the cu-zn multilayer and cu-zn solid solution. a lamellar structure with the hardness of about 130 vhn was formed after eight arb cycles. following to the suitable heat treatment, a solid solution with a uniform microstructure and hardness of about 57 vhn was produced. the dominant wear mechanism in the arb processed multilayer was found to ...

In this study, the effect of cladded tungsten carbide layer upon HSS - M2 tool steel on microstructure, hardness, and wear behavior has been studied in two cases without using the middle layer and using the middle layer of nickel. Tungsten Carbide cladded on HSS - M2 tool steel by Arc Weld ( SMAW ). The ASTM-G65 wear test was used to determine its application for use in the mineral indus...

The article describes a case in which a popliteal cyst was identified presenting as a mass on the anterior aspect of theright tibia. This occurred as a result of polyethylene wear debris from previous total knee arthroplasty. Although alternativediagnoses for an anterior tibial mass are more likely, a popliteal cyst must be considered, particularly if the patient has ahistory of total knee arth...

Proponents of the biological theory of aseptic loosening have in recent years tended to concentrate on the production and distribution of particulate ultra-high-molecular-weight polyethylene (UHMWPE) debris around the potential joint space. However, mechanical loading of cemented implants with the differing elastic moduli of metal stems, polymethylmethacrylate (PMMA) cement and bone can result ...

Intermetallic compounds have been studied for their potential application as structural wear materials or coatings on engineering steels. In the present work, a newly designed intermetallic composite in a Ni-Mo-Si system was fabricated by arc-melting process with commercially pure metal powders as starting materials. The chemical composition of this intermetallic composite is 45Ni-40Mo-15Si (at...