نتایج جستجو برای: 7-alumina

تعداد نتایج: 654484  

2005
Liang A. Xue I - Wei Chen

9 = 0.6 I / s ' 7 = 6.0 0 7 = 2 4 i ti 3 = 6 0 Through close control over green-state powder processing, pure alumina ceramics of 0.5-pm grain size were obtained by sintering at 1250°C. The static grain growth of this material was modest at temperatures below 1300°C. However, dynamic grain growth occurred rapidly during superplastic deformation. Therefore, although the ultrafine-grained alumina...

2008
Ali Moghimi

Alumina phase loaded with ammonium pyrrolidine dithiocarbamate (APDC )were synthesized based on chemical binding and physical adsorption approaches. The stability of a chemically modified APDC especially in concentrated hydrochloric acid which was then used as a recycling and pre-concentration reagent for further uses of alumina immobilized APDC phase. The application of this alumina for sorpti...

Journal: :journal of physical & theoretical chemistry 2006
mehdi vadi gholamreza farmani hamidreza seyedjafari m. sohrabi

the series of mono-metallic and bi-metallic catalysts have been prepared by impregnatingwith solutions containing compound of h2ptc15,nbc15 and lml hc1 (0.1 mol). the activityand selectivity of the catalysts have been determined under conditions at 450-500°c, 15-30atm. molar ratio h2/c7h16=5 and vvh=1.5/h for converting n-heptane. under theseexperimental conditions it has been established that ...

, ,

The purpose of this study was to investigate the effect of high alumina cement and Sintering temperature on microstructure, physical and mechanical properties of foamed alumina insulation bricks. The Slurry samples  were prepared containing 75wt% of alumina and 25% wt of deionised water containing 1%, 3%, 5%, 7% wt% high Alumina cement and 2% wt% foam. Then samples were poured into metal molds....

Journal: :International Journal of Molecular Sciences 2009
Bassie B. Marvey

Self- and cross-metathesis of fatty acid methyl esters (FAMEs) was investigated using a silica alumina supported Re(2)O(7) catalyst. Although a 3 wt% Re(2)O(7)/SiO(2)-Al(2)O(3)/SnBu(4) is already active for the metathesis of unsaturated FAMEs, the results have shown that particle size of silica alumina support has a profound influence on its activity and selectivity. Consequently, high substrat...

2004
D.-A. Borca-Tasciuc G. Chen A. Prieto M. S. Martín-González

Bismuth telluride nanowires are of interest for thermoelectric applications because of the predicted enhancement in the thermoelectric figure-of-merit in nanowire structures. In this letter, we carried out temperature-dependent thermal diffusivity characterization of a 40 nm diameter Bi2Te3 nanowires/alumina nanocomposite. Measured thermal diffusivity of the composite decreases from 9.2310−7 m2...

2013
Masahiro Hasegawa Akihiro Sudo

BACKGROUND Zirconia was introduced as an alternative to alumina for use in the femoral head. The yttria stabilized zirconia material was improved by adding alumina. We evaluated highly cross-linked polyethylene wear performance of zirconia in total hip arthroplasty. The hypothesis was that alumina stabilized zirconia could decrease highly cross-linked polyethylene wear. METHODS Highly cross-l...

2001
E. Chibowski

Catechin belongs to a group of flavonoids, which are present in many fruits and plants. Catechin is often employed in model investigations on antioxidant behavior of flavonoids. Recently also some anti-disease properties of flavonoids were reported. In this paper investigations were carried out on alumina/(+ )-catechin solution system. FTIR spectra were taken for the catechin samples retaken fr...

2007
Jong S. Kim Won S. Choi Dongwook Kim Andrei Shkel Chin C. Lee

Large 6 mm× 9 mm silicon chips have been successfully bonded to alumina substrates with electroplated Au/Sn/Au structure at the eutectic omposition. The new bonding process is entirely fluxless, or flux-free. It is performed in vacuum (50 milliTorrs), where the oxygen content is educed by a factor of 15,200 comparing to air, to inhibit solder oxidation. Eutectic Au80Sn20 alloy is a well establi...

2011
N. Eswara Prasad

The main aim of this paper was to determine the amount of Al2O3 reinforcement that results into best combination of strength. Magnesium nano composites containing 3.5, 7.0 and 14 volume percentage of Al2O3 were synthesized through powder metallurgy route. Resistance of furnace sintering technique (heating rate: 49°C/min).Micro structural characterization revealed reasonably uniform distribution...

نمودار تعداد نتایج جستجو در هر سال

با کلیک روی نمودار نتایج را به سال انتشار فیلتر کنید