the plain carbon steel “ck45” has relatively well mechanical and metallurgical properties and low cost. the purpose of this research was the property evaluation of this steel on abrasive wear and impact for using in plows and other tillage tools. tillage tool should resist in abrasive wear and impact simultaneously. several heat treatments were done on specimens of this steel. a standard test d...

Friction and abrasive surface treatment of engineering steels is the new effective tool for surface material strengthening and improving the resistance to fatigue damage. The specific abrasive machining of medium-carbon steel yields formation of surface hardened layer with super dispersed nanocrystal structure which increase the fatigue damage resistance in times. The present study aimed to est...

The wear resistance of microfilled and conventional composite resins, was examined, using two sizes of abrasive particles for polishing. The mechanical properties of the composite resins were also studied and evaluated in relation to wear. Conventional composites showed much lower wear resistance than the microfilled resins. The amalgam and human enamel abraded with 10ƒÊm SiC particles, had str...

Stainlesssteel 403 is high-alloysteelwith good corrosion resistance and it’svery hard material. Abrasive water jet is an effective method for machining, cutting and drilling of stainlesssteel 403. In thispaperweoptimize the metalremoval rate of stainlesssteel 403 in abrasive water jet machining. The MRRisoptimize by usingthreeparameters water pressure, abrasive flow rate and stand-off distance ...

An in vitro study was conducted to evaluate the abrasive wear resistance of high-strength denture teeth (HS teeth). Eight types of specimen were used in the experiments; 3 types of HS teeth, 3 types of conventional plastic denture teeth (PL teeth), porcelain teeth and metal teeth. Sliding-induced wear tests were conducted by sliding the samples on a metal plate. The abrasive wear resistance of ...

in this study; utilizing the elastic matrix ball has higher processing efficiency and better superficial quality than traditionalgrinding. the diversity of elastic abrasive tool characteristics contact with bend surface results in irregular wear abrasion，and abrasive tool machining status gets complicated. there is no theoretical interpretation of parameters affecting the grinding accuracy. bec...

This paper aims to compare the tribo-mechanical properties and structure–property relationships of a wear resistant cobalt-based alloy produced via two different manufacturing routes, namely sand casting and powder consolidation by hot isostatic pressing (HIPing). The alloy had a nominal wt % composition of Co–33Cr–17.5W–2.5C, which is similar to the composition of commercially available Stelli...

In present investigation the wear behavior of treated and untreated coir dust filled epoxy resin matrix composites were studied. The effect of treated and un treated coir dust concentration (10%, 20% and 30%), varying loads (10, 20 and 30N) and varying velocities (300, 400 and 500) on the abrasive wear rate of composite has been analyzed. The abrasive wear property of the composite is examined ...

Adhesion strength of exterior or interior coating of steel pipes is too important. Increasing of coating adhesion on surfaces can increase the life time of coating, safety factor of transmitting line pipe and decreasing the rate of corrosion and costs. Preparation of steel pipe surfaces before doing the coating process is done by shot and grit blasting. This is a mechanical way to do it. Some e...

Introduction: Low resistance of composite resins to abrasion is a primary concern in the application of these materials for posterior restorations which are prone to high occlusal loads. This study compared the wear resistance of three types of composites. Methods: In this laboratory experiment, five specimens of each of the three types of composites (z250, Heliomolar, Opallis) were prepared...