In this paper, we implement a circuit topology for the gold standard ATX80+.The total output power is 255 watts under full load operation. An active-clamping ZVS forward converter is adopted to provide main power and in secondary side, the BUCK circuit technology is adopted to provide 3 sets power +12V, +5V and +3.3V. To eliminate the current harmonics and to achieve high power factor, an activ...

the radiation power loss from a magnetically confined plasma in a stellarator has been calculated using neoclassical particle and energy fluxes in an energy balance equation. we could obtain a power loss of about 34% of the total input power by numerical calculation. this fraction of the power loss has been found to be in good agreement with the experimentally measured values of 30-40% for our ...

this paper presents a comparative analysis between two current control strategies, constant source power and generalized fryze current, used in active power filter (apf) applications having three different modulation methods. the hysteresis band (hb) and first-order delta-sigma modulation (dsm) as well as the second-order dsm is applied. the power section of the active power filter is viewed as...

This study presents a finding an optimal location and best parameter setting of Unified Power Flow Controller (UPFC) by Bacterial Foraging Optimization Algorithm (BFOA) for minimizing the active and reactive power loss in power system. The UPFC is one of the important Flexible Alternating Current Transmission System (FACTS) device that control simultaneously voltage magnitude at the sending end...

Abstract The bushing is one of the most important components power transformer, and it very to find internal defects bushings as soon possible, effectively accurately diagnose its insulation state information. In this paper, active loss 500kV transformer have been analyzed, evaluation method based on proposed. To verify feasibility method, abnormal was selected analyze state. result shows that ...

the doubly fed induction generator (dfig) is one of the most popular technologies used in wind power systems. with the growing use of dfigs and increasing power system dependence on them in recent years, protecting of these generators against internal faults is more considered. loss of excitation (loe) event is among the most frequent failures in electric generators. however, loe detection stud...

This paper utilizes the application of Particle Swarm Optimization (PSO) and Genetic Algorithm (GA) techniques to find the most appropriate locations of Unified Power Flow Controller (UPFC) with optimum cost of generation for loadability limit and minimum active power loss, while satisfying the power system constraints. Two objective functions are taken as the indexes of the system performance:...

This paper assesses the electrical characteristics of piezoelectric wafers for use in aeronautical applications such as active noise control in aircraft. Determination of capacitive behavior and power consumption is necessary to optimize the system configuration and to design efficient driving electronics. Empirical relations are developed from experimental data to predict the capacitance and l...

With the development of concentrated wind power areas, new energy’s dispatching problems are more prominent with its fast expansion. However, we can maximize the utilization of wind power under power curtailment conditions by optimal wind power dispatching. The paper studies on the basic theories of wind power turbines, and analyses the power’s control and output characteristics of wind turbine...