Beam quality correction, kQQ0(r), for solid-state detectors diamond, LiF, Li2B4O7, Al2O3, and plastic scintillator are calculated as a function of distance, r, along the transverse axis of the 60Co and 192Ir brachytherapy sources using the Monte Carlo- based EGSnrc code system. This study also includes calculation of detector-specific phantom scatter correction, kphan(r), for solid phantoms suc...

The photocatalytic oxidation of phenol in water in the band reactor with supported TiO2 catalysts was investigated. Modified anatase/Al2O3 catalysts were used as the photocatalysts. The main aim of these studies was to determine catalytic activity of TiO2/Al2O3 and V-TiO2/Al2O3 in the removal of phenol from water. The effectiveness was measured in the configurations: TiO2/UV/O2/H2O2, TiO2/O2/H2...

The goal of this paper is to experimentally study the behavior of nanofluid to improve the performance of a circular heat pipe. Pure water and Al2O3-water based nanofluid are used as working fluids. An experimental setup is designed and constructed to study the heat pipe performance under different operating conditions. The effect of filling ratio, volume fraction of nano-particle in the base f...

We report on the suitability of water-soluble non-polymeric electrospun cyclodextrin (CD) nanofiber templates by using atomic layer deposition (ALD) to yield metal oxide tubes. To demonstrate this, watersoluble electrospun CD nanofibers were chosen as template to produce metal oxide tubes where we have tested two examples of ALD coatings, namely, Al2O3 and ZnO. After the ALD coating on the CD n...

Thermal enhancement of a single mini channel in Proton Exchange Membrane Fuel Cell (PEMFC) cooling plate is numerically investigated. In this study, low concentration of Al2O3 in Water Ethylene Glycol mixtures is used as coolant in single channel of carbon graphite plate to mimic the mini channels in PEMFC cooling plate. A steady and incompressible flow with constant heat flux is assumed in the...

Experimental investigation of heat transfer during pool boiling of two nanofluids, i.e., water-Al2O3 and water-Cu has been carried out. Nanoparticles were tested at the concentration of 0.01%, 0.1%, and 1% by weight. The horizontal smooth copper and stainless steel tubes having 10 mm OD and 0.6 mm wall thickness formed test heater. The experiments have been performed to establish the influence ...

Palladium nanoparticles were grown on sub-millimeter activated Al2O3 particle support by spraying H2PdCl4 solution evenly onto the support, followed with a thermal reduction under H2 atmosphere. Compared with its counterpart created by the conventional impregnation method, the Pd/Al2O3 catalyst created by the spray process could enrich the existence of active Pd nanoparticles on the surface of ...

Natural heat convection of water-based alumina (Al2O3/water) nanofluids (with volume fraction 1% and 4%) in a horizontal cylinder is numerically investigated. The whole three-dimensional computational fluid dynamics (CFD) procedure is performed in a completely open-source way. Blender, enGrid, OpenFOAM and ParaView are employed for geometry creation, mesh generation, case simulation and post pr...

This work reports on recent advances in the deposition of non-wettable coatings with high water contact angles (WCAs). We propose a simple and easily-controlled method for fabricating different types of nanoestructured films of Al2O3 with hydrophobic properties by Physical Vapour Deposition (PVD). The films have been deposited over three types of hydrophilic substrates with very different value...

double-diffusive mixed convection in a lid-driven square enclosure filled with al2o3-water is numerically investigated. two-dimensional nonlinear governing equations are discretized using the control volume method and hybrid scheme. the equations are solved using simpler algorithm. the results are displayed in the form of streamlines, isotherms, and iso-concentrations when the richardson number...