The mechanical behavior of rough interfaces is modeled from a micromechanical viewpoint. A kinematically driven mechanistic approach is adopted which explicitly considers the interaction of asperities on the fracture surface. The mating asperities are assumed to behave in accordance with contact mechanics postulates of non-conforming bodies. The roughness of the fracture surface is represented ...

Ruff, L.J., 1992. Asperity distributions and large earthquake occurrence in subduction zones. In: T. Mikumo, K. Aki, M. Ohnaka, L.J. Ruff and P.K.P. Spudich (Editors), Earthquake Source Physics and Earthquake Precursors. Tectonophysics. 211: 61-83. Plate tectonics and the seismic gap hypothesis provide the framework for long-term earthquake forecasting of plate boundary earthquakes. Unfortunate...

The characteristics of near-fault ground motion are investigated considering heterogeneous slip distribution on the fault plane. Areas on the fault plane with large slip in compare with the average slip on the fault are known as asperity. The characteristics of strong ground motions in near-fault area are strongly affected by faulting parameters such as asperity location, maximum slip of asperi...

Modelling of the contact between moving rough surfaces allows a better understanding of friction and wear mechanisms, which can be used in engineering solutions. This issue has been examined using a number of approaches. The statistical type of a contact model is still the most popularmodel used in rough surfaces contact.This statement does not mean that it is the best solution of contact rough...

A three-dimensional thermo-mechanical model is developed for the transient contact between a thermal flying height control (TFC) slider and a disk asperity. The effect of contact conditions is investigated, including the friction coefficient and the circumferential disk velocity. The damage of the read–write shields due to contacts with disk asperities is studied along with the maximum temperat...

In this investigation three effects are included in a recently developed scale-dependent multi-asperity model of elastic contact and friction. First, a Weibull distribution of asperity heights is used, which allows the skew and kurtosis to be varied, but not independently of each other. Second, the effect of non-constant radii of curvature of the asperity summits, with the curvature varying wit...

We report on the successful realization of a contactless, non-perturbing, displacement-measuring system for characterizing the surface roughness of polymer materials used in tribological applications. A single, time-dependent, scalar value, dubbed the collective micro-asperity deformation, is extracted from the normal-displacement measurements of normally loaded polymer samples. The displacemen...

Ultra high molecular weight polyethylene (UHMWPE) submicron wear debris particles in total joint replacement (TJR) prosthesis have been observed clinically to cause osteolysis. In this study, the formation of UHMWPE submicron wear debris was investigated by modeling a nanoscale asperity on the surface of a CoCr femoral component of a total knee replacement (TKR) prosthesis using a Si3N4 AFM com...

The paper presents results obtained using a transient analysis technique for point contact elastohydrodynamic lubrication (EHL) problems based on a formulation that couples the elastic and hydrodynamic equations. Results are presented for transverse ground surfaces in elliptical point contact that show severe film thinning and asperity contact at the transverse limits of the contact area. This ...

The traction developed between a thin flexible web, wrapped around a non-vented, rotating cylindrical roller is studied experimentally and theoretically. A series of eight webs representing a wide range of surface roughness characteristics are traction-tested against the same roller over a wide speed range. A mathematical model that couples air film pressure, web deflection, and asperity deform...