In this paper, the mechanical properties and tensile failure mechanism of two novel bio-absorbable as-cast Mg-Zn-Se and Mg-Zn-Cu alloys for endovascular medical applications are characterized. Alloys were manufactured using an ARC melting process and tested as-cast with compositions of Mg-Zn-Se and Mg-Zn-Cu, being 98/1/1 wt.% respectively. Nanoindentation testing conducted at room temperature w...

Cavities and ageing leads to a higher demand for robust and durable dentures. Cobalt chromium dental cast alloys fulfill these requirements. After the casting, the alloys have to be thoroughly cleaned in an electrochemical dissolution bath. In the existing technology an expert has to control the polishing process. In this paper we present a fuzzy logic controller with 16 fuzzy rules, which comp...

The cytotoxicity of a series of dental casting alloys in the as-cast and polished condition was determined with cell culture techniques involving phase contrast microscopy to examine cell morphology and the succinic dehydrogenase histochemical reaction to measure any ring of inhibition of Balb/c 3T3 cellular respiration around alloys. Crown and bridge casting alloys and a nickel- and a cobalt-b...

The P content dependencies of the nanocrystallization behaviors and high temperature magnetic properties of the Fe 54.6 Co 29.4 Si 2.8 (B 0.8ÀY P Y) 14 Nb 1 Cu 1 (Y ¼ 0, 0.2, and 0.3) alloys have been investigated. Alloys were prepared by melt spinning and subsequently annealed in an argon atmosphere to induce nanocrystallization. P addition increases primary crystallization temperature (Tx 1),...

Hypereutectic aluminum silicon alloys are mainly used in cast form in important components like pistons, cylinder liners, rocker arms, air conditioner compressors, brake drums, engine blocks, etc. These have inherent advantages of being high wear resistance, high strength to weight ratio, high corrosion resistance, good cast performance, high thermal conductivity, good weldability, etc. The inf...

Cast aluminum alloys are widely applied for the transportation industry. Alloys with silicon and magnesium as the main alloying elements are the most important of the aluminum casting alloys because of their high fluidity. However, Al-Si-Mg alloys have exhibited medium strength level at room and, especially, at elevated temperature. Recently, new casting alloys with high magnesium and silicon h...

The article deals with measurements of linear changes of castings from foliated graphite cast iron and Al-alloys during their solidification. For this purpose the measuring apparatus, which applies a dilatometer of Polish provenience, was built up. Dilatation curves of graphite cast iron and Al-alloys were acquired during the casting process. In the case of Al-alloys the influence of chemical c...

L. Kuchariková, E. Tillová, J. Belan, M. Chalupová, A. Vaško, I. Švecová, University of Žilina, Faculty of Mechanical Engineering, Slovakia The present work deals with evaluation of eutectic Si (its shape, size, and distribution), dendrite cell size and dendrite arm spacing in aluminium cast alloys which were cast into different moulds (sand and metallic). Structural parameters were evaluated u...