Assessment of creep damage and residual creep life of a cast HP 40 Nb Mod. Reformer tube was performed, wherein the experimental Larson–Miller diagram and area fraction of creep voids were adopted. The state of damage of the tube in service was metallographically analyzed by using light and electron microscopy. Samples from the serviced reformer furnace tube were cut and prepared for void exami...

Abstract: mechanical properties of AISIH 13 hot-work tool steel have been studied. Cast samples made of the modified new steel were homogenized and austenitized at different conditions, followed by tempering at the specified temperature ranges. Hardness, red hardness, three point bending test and Charpy impact test were carried out to evaluate the mechanical properties together with characteriz...

In this work, the evolution of MC-type Nb-rich primary carbides in a 35Ni-25Cr-Nb-type refractory alloy, commonly known as HP40-Nb, and its transformation into Ni-Nb silicide G-phase (Ni16Nb6Si7), has been studied. For purpose, experimental technique scanning electron microscopy was used together with X-ray microanalysis to detect changes chemical composition niobium carbide over time at given ...

S. Rešković, I. Jandrlić, University of Zagreb, Faculty of Metallurgy, Sisak, Croatia, F. Vodopivec Institute of Metals and Technology, Ljubljana, Slovenia Using thermal imaging camera during tensile testing of low carbon and Nb microalloyed steel influence of testing rate on start of plastic deformation was investigated. The results showed that the onset of plastic flow is significantly differ...

Press hardening steel has become a much used material in car body manufacturing due to its excellent safety and lightweight potential. In some recent car models press hardening steel has reached already a weight share of more than 20% in the body structure while it is estimated that it could reach even around 40% in the future. However conventional press hardening steel based on the alloying co...

Large diameter steel line pipes are generally produced by cold deforming hot rolled or thermomechanically controlled rolled (TMCR) plate by the three-stage 'UOE' process. Pipe strength has been found to increase or decrease relative to the plate, depending on the steel grade and plate processing history. The strength increase is due to work hardening whereas any decrease in strength arises from...

Dose distribution was calculated and analyzed on the basis of 16-bit computed tomography (CT) images in order to investigate the effect of scanning conditions on CT for metal implants. Stainless steel and titanium rods were inserted into a phantom, and CT images were obtained by scanning the phantom under various scanning conditions: i) Fixed tube current of 230 mA and tube voltages of 100, 120...

In this paper, a new type of steel-concrete composite member, concrete-filled core steel tube with outer angle steel plank reinforced concrete stub column, is proposed and a series of nonlinear 3D(three-dimensional) full-range numerical calculations under axial compression are carried out, some important factors are analyzed, such as the strength of the concrete, the steel tube and the angle st...