master moulds are used to cast copper anode moulds. these iron moulds are made of grey or nodular cast irons. according to desirable properties of ductile irons, it was expected that ductile cast iron moulds could have performed their nominal life. but in service, these moulds have not performed their nominal life and they have experienced premature failures due to warping and cracking. also gr...

Master moulds are used to cast copper anode moulds. These iron moulds are made of grey or nodular cast irons. According to desirable properties of ductile irons, it was expected that ductile cast iron ...

OBJECTIVE The purpose of this study was to validate the therapeutic efficacy of the innovative surgical approach using laparoscopy, atelocollagen sponge, and hand-made mould on the achievement of a satisfactory neovagina in patients with vaginal agenesis. STUDY DESIGN The current study involved four patients diagnosed as having Mayer-Rokitansky-Küster-Hauser syndrome. After creating a vaginal...

During the demoulding stage of the hot embossing process, the force required to separate a polymer part from the mould should be minimized to avoid the generation of structural defects for the produced micro structures. However, the demoulding force is dependent on a number of process factors, which include the material properties, the demoulding temperature, the polymer pressure history and th...

The number of words should not exceed 350 Self-powered infusion micropump is a non-mechanical micropumps for microfluidics application. A three- dimensional (3D) printing an intelligent additive manufacturing technique that permits cheap, fast and accurate geometrically complex designs. In this study, self-powered master mould was fabricated using stereolithography (SLA) 3D characterized accord...

Estuary basin is a fertile area which has important role for sustaining many organisms from estuary and sea. Mould and other saprobic microorganisms have important role to decomposing organic material in estuary water. A study on diversity and abundance of mould inhabiting Muara Layang estuary sediment, Bangka Belitung Islands has not been conducted before. The objective of this study is to inv...

Traditional environmental mould analysis is based on microscopic observations and counting of mould structures collected from the air on a sticky surface or culturing of moulds on growth media for identification and quantification. These approaches have significant limitations. A DNA-based method of mould analysis called mould specific quantitative PCR (MSQPCR) was created for more than 100 mou...

The making of ear mould for hearing aids is generally considered to be a safe process. However, there are a few reported cases of complications caused during mould making. We report the case of a man with 69 years age, where the process of making the mould for a hearing aid led to the perforation of the tympanic membrane and pouring of mould material into the middle ear, necessitating surgical ...

This article is focused on the calculation of heat radiation intensity and its optimization on an aluminum mould surface. The inside of the mould is sprinkled with a special powder and its outside is heated by infra heaters located above the mould surface, up to a temperature of 250°C. By this way artificial leathers in the car industry are produced (e. g. the artificial leather on a car dashbo...