Two-dimensional micro-bubble actuator arrays were developed and studied in detail to enhance the hybridization kinetics of a DNA micro-biosensor. The hybridization between a molecular beacon, a kind of oligonucleotide probe, and its complement was investigated in a millimeter-sized PDMS based reaction chamber, where various 2D micro-heater arrays were distributed on the bottom for micro-bubble ...

Two-phase flow regimes are affected by conduit position, alignment, geometry, flow direction, physical characteristics, and flow rate of each phase as well as the heat flux toward the boundaries. Due to the importance of two-phase flow, numerous regimes have been identified. The first step in studying micro-bubble formation inside a venturi tube is to recognize the type of flow regimes. In this...

The present study considers of the water and air flow and Micro-Bubble production inside the venturi tube, by the use of dimensional analysis. Numerical analysis of Micro-Bubble creation in venturi tube requires fast computers and large amounts of storage space. Up to now, there has been no numerical analysis concerning Micro-Bubble creation and all other existing studies are experimental. To s...

A high-sensitivity, low-cost, ultrathin, hollow fiber micro bubble structure was proposed; such a bubble can be used to develop a high-sensitivity strain sensor based on a Fabry-Perot interferometer (FPI). The micro bubble is fabricated at the fiber tip by splicing a glass tube to a single mode fiber (SMF) and then the glass tube is filled with gas in order to expand and form a micro bubble. Th...

This paper describes various manipulations of micro air bubbles using electrowetting on dielectric (EWOD): transporting, splitting, merging and eliminating. First, in order to understand the response of bubbles to EWOD, the contact angle modulation is measured in a capped air bubble and confirmed to be in good agreement with the Lippmann-Young equation until saturation. Based on the contact ang...

Related Articles Dynamics of micro-bubble sonication inside a phantom vessel Appl. Phys. Lett. 102, 013702 (2013) Bubble-driven inertial micropump Phys. Fluids 24, 122003 (2012) Effect of viscosity and shear flow on the nonlinear two fluid interfacial structures Phys. Plasmas 19, 122105 (2012) Bubble nucleation on nanoto micro-size cavities and posts: An experimental validation of classical the...

in this research, the effect of micro turbulence on the flotation rate of quartz particles was investigated. the maximum particle reynolds number (rep) was obtained at 60.25 with a particle size of -500+420 µm, impeller speed of 900 rpm, bubble surface area flux of 10.21 1/s and micro scale turbulence size of 162 µm. when the micro turbulence size was equal to the particle size, the maximum flo...

Advances in the apptication of supercritical (SC), gaseous (G), and ]iquid (LQ) C02 hayc been made regarding the interaction with biological materials or organisms. There are sevcral reports dealing with the influences of SC, G, and LQ C02 on proteins,i'2) amino acids,i) enzymes,3'S) and microbial eells.b'7) Kamihara et aL have described that wet cells (water content of 70-90g,h) of baker's yea...

Nucleate boiling heat transfer coefficients may be strongly reduced by scale formation, even for conditions where the bulk foulant concentration is well below the saturation concentration. Due to the mechanism of micro-layer evaporation, the local concentration at the heat transfer surface can be considerably increased, causing the formation of scale and changes in bubble frequency and bubble d...