In this paper, a novel switched-capacitor DC-DC converter with pulse density and width modulation (PDWM) is proposed with reduced output ripple at variable output voltages. While performing pulse density modulation (PDM), the proposed PDWM modulates the pulse width at the same time to reduce the output ripple with high power efficiency. The prototype chip was implemented using 65 nm CMOS proces...

Conventional switched capacitor converters have an inherent drawback that their efficiency decreases as the output current increases. This inherent drawback is due to a periodical forced charging and discharging operation in the internal switched capacitors accompanied by a large capacitor current. Their efficiency can not be increased by decreasing its internal resistance. As a result, convent...

This paper analyzes the advantages and limitations of using the floating(or flying-) capacitor technique as a building block with differential input and either differential or single-ended output to implement voltage amplifiers, multiplexers, and coherent amplitude demodulators. Theoretical analysis, supported by experimental results, shows that the fully differential configuration has a better...

A low voltage switched-capacitor circuit that generates an almost constant reference current across process, voltage and temperature (PVT) is proposed. The reference voltage is generated by a low voltage band-gap circuit. The output reference current is obtained by applying the generated reference voltage to a low voltage V – I converter. The resistor in the proposed V – I converter is further ...

In the conventional DC-AC inverter consisting of two DC-DC converters with unipolar output capacitors, the output capacitor voltages of the DC-DC converters must be higher than the DC input voltage. To overcome this weakness, this paper proposes a single-phase DC-AC inverter consisting of two embedded Z-source converters with bipolar output capacitors. The proposed inverter is composed of two e...

A switchable operational amplifier (op-amp) that uses a switched capacitor integrator has an advantage such as low power consumption and wide gain-bandwidth product. The power reduction is achieve by apply switching samples at the input and output capacitors. These capacitors can be otherwise would contribute in increase in power consumption. During the first phase of the sample the opamp compl...

A 1.21V output, 100mA, 0.1μF-10μF output capacitor, ESR-independent, low voltage, low drop-out voltage regulator for portable power applications is designed and fabricated in a 0.5μm CMOS process with an area of 0.22 mm. The use of a wide-range output capacitor LDO enables reduced target system PCB size and Bill of Materials (BOM). A 0.05%/V line regulation, 0.001%/mA load regulation with 220mV...

One of the most efficient lighting technology is based on light-emitting diodes (LEDs). Common LED drivers with AC-input (50-60Hz) usually require a bulk electrolytic capacitor to decrease low-frequency ripple in the output. However, the critical element that limits the lifespan of the LED driver is the electrolytic capacitor. An isolated off-line LED driver is proposed in this paper, in which ...

In this paper an analytic approach to estimate the nonlinearity of radix-4 pipelined analog-to-digital converters due to the circuit non-idealities is presented. Output voltage of each stage is modeled as sum of the ideal output voltage and non-ideal output voltage (error voltage), in which non-ideal output voltage is created by capacitor mismatch, comparator offset, input offset, and finite ga...