A physically-based two-site mean field model has been developed to describe the microstructural evolution due to recrystallization during and after deformation. The model has been applied to predict the recrystallized fraction, recrystallized grain size, and flow stress of 304L austenitic stainless steel during discontinuous dynamic recrystallization (DDRX), post-dynamic recrystallization (PDRX...

in this work dynamic recrystallization behavior of aisi 403 martensitic stainless steel was studied using hot compression tests over temperature range of 900 c -1200 c and strain rate range of 0.001 s-1 - 1 s-1. the obtained flow curves showed that the hot compression behavior of the alloy is controlled by dynamic recrystallization. the flow stress and strain corresponding to the critical, pe...

determination of critical points on hot stress-strain curve of metals is crucial in thermo-mechanical processes design. in this investigation a mathematical modeling is given to illustrate the behavior of metal during hot deformation processes such as hot rolling. the critical strain for the onset of dynamic recrystallization has been obtained as a function of strain at the maximum stress. in a...

A mesoscale model is developed by integrating the rate theory and phase-field models and is used to study the fission-induced recrystallization in U-7Mo alloy. The rate theory model is used to predict the dislocation density and the critical size and density of the recrystallized nuclei due to irradiation. The predicted fission rate and temperature dependences of the dislocation density are in ...

Recent work has indicated that iron (oxyhydr-)oxides are capable of structurally incorporating and releasing metals and nutrients as a result of Fe2+-induced iron oxide recrystallization. In the present paper, we briefly review the current literature examining the mechanisms by which iron oxides recrystallize and summarize how recrystallization affects metal incorporation and release. We also p...

Monte Carlo (MC) simulations for recrystallization were performed using OIM (Orientation Image Microscopy) data sets to define the initial microstructures. Two types of OIM data sets were used as input to the simulations. One type was measured on a warm-rolled interstitial-free (IF) steel sheet. The results were strongly affected by the assumptions used to estimate the stored energy, which is t...

Recrystallization rate of ice crystals in 33% sucrose solutions, a model frozen dessert, was measured in the presence of antifreeze protein Type I (AFP type I) at -10°C, which is relevant to practical storage or distribution temperature of frozen dessert. The concentrations of AFP type I were set to 0.01, 0.1, and 1g/ml, respectively. Ice crystals during recrystallization process were observed...

in the present work the recrystallization behavior of deep drawing grade al-killed low carbon steel sheets produced by mobarakeh steel plant (msp) has been studied. salt bath isothermal annealing has been applied to cold rolled samples and the resulted microstrucrures have been compared with the microstructure obtained from the box annealing process in msp. it is found that at 635 and 700ºc the...

An Al-0.3%Cu alloy was deformed to high strains by cold rolling. The as-deformed samples were annealed at different temperatures until complete recrystallization. The cold rolling textures were determined by X-ray diffraction while the recrystallization textures and microstructures were characterized by electron backscatter diffraction. It was found that the rolling texture was characterized by...

Tough pitch copper wire (99.97% Cu) is generally characterized by the spiral elongation number. The principle of the test is based on the influence of impurities on the recrystallization kinetics. Alternative non-metallographic techniques to characterize the recrystallization kinetics have been investigated in this study, such as differential scanning calorimetry (D.S.C.) and residual electrica...