Experiments were carried out in which the dependence of the fractional softening on temperature, time and strain rate was determined in a 304H stainless steel. Three prestrain ranges were identified pertaining to three different post-deformation softening behaviors: 1) prestraining to below the DRX critical strain: strongly strain dependent softening by SRX alone with softening kinetics control...

experiments were carried out in which the dependence of the fractional softening on temperature, time and strain rate was determined in a 304h stainless steel. three prestrain ranges were identified pertaining to three different post-deformation softening behaviors: 1) prestraining to below the drx critical strain: strongly strain dependent softening by srx alone with softening kinetics control...

In this work dynamic recrystallization behavior of AISI 403 martensitic stainless steel was studied using hot compression tests over temperature range of 900 C -1200 C and strain rate range of 0.001 s-1 - 1 s-1. The obtained flow curves showed that the hot compression behavior of the alloy is controlled by dynamic recrystallization. The flow stress and strain corresponding to the critical, pe...

in this work dynamic recrystallization behavior of aisi 403 martensitic stainless steel was studied using hot compression tests over temperature range of 900 c -1200 c and strain rate range of 0.001 s-1 - 1 s-1. the obtained flow curves showed that the hot compression behavior of the alloy is controlled by dynamic recrystallization. the flow stress and strain corresponding to the critical, pe...

We present the first single-molecule atomic force microscopy study on the effect of chemical denaturants on the mechanical folding/unfolding kinetics of a small protein GB1 (the B1 immunoglobulin-binding domain of protein G from Streptococcus). Upon increasing the concentration of the chemical denaturant guanidinium chloride (GdmCl), we observed a systematic decrease in the mechanical stability...

Analysis of the dynamic evolution of multilevel structure during martensitic transformations provides kinetics-based constitutive relations for transformation plasticity. Application in numerical modeling of ductile fracture by microvoid-softening-induced shear localization, in conjunction with metallographic study of crack-tip processes, identifies transformation toughening mechanisms operatin...

A constitutive model of bulk metallic glass (BMG) plasticity is developed which accounts for finitedeformation kinematics, the kinetics of free volume, strain hardening, thermal softening, rate-dependency and non-Newtonian viscosity. The model has been validated against uniaxial compression test data; and against plate bending experiments. The model captures accurately salient aspects of the ma...

The physical basis and a mathematical formulation of a softening model nicknamed Alsoft, accounting for the combined effect of recovery and recrystallization during annealing of heavily deformed aluminium alloys have been presented. The prediction power of the model is tested against experiments in terms of softening kinetics and final grain structure of selected Al-MnFe-Si-model alloys with di...

Push-pull tests at fixed plastic strain amplitude or stress were run on a TWIP steel, and followed by TEM observations, to analyze its cyclic behavior in relation with the deformation mechanisms. The kinematic isotropic components of flow measured throughout whole hardening/softening stages, their evolution cumulated was compared those tension. rise internal found responsible for initial harden...