In cookware industry, interior spray coating process is an important process to protect the cookware product from the corrosion. In this process, the coating material “TEFLON” is used to spray to cover all the part’s surface. If a pot or pan is not too deep, one spray gun is enough to spray to cover all the interior surface. However, for the high side-wall pot, two spray guns must be used to sp...

Impressive gains have been made in thermal spray coatings through material development and coating parameter selection. Nevertheless, it is usually up to shop personnel to develop a robot program to achieve the final coating. Coating programs are often developed using trial and error. Some motion and deposit analysis programs are available [1], [2]. However, they can be costly and require a lev...

The aim of the present work was to study the effect of various process parameters on an aqueous-based film coating process of tablets performed in a side-vented perforated pan-coating apparatus. Results of preliminary trials indicate that spray rate, inlet air temperature, percentage solid content, atomizing air pressure and speed of rotation affected characteristics of coating. A 3 full factor...

A fundamental study on the effect that pre-coating a substrate with metal spraying has on the properties of sputtered Titanium-nitride film (TiN film) was carried out. The residual stresses in TiN films sputtered on the substrates coated with various spray coatings were measured by X-ray stress measurement. It was observed that the residual stresses in TiN films sputtered on substrates coated b...

Technical development and commercial implementation of the supercritical fluid spray process have produced the surprising result that coating appearance and performance can actually be improved by removing 60 to 80 percent of the organic solvent from solvent-borne coating formulations. Unlike normal diluent solvents and water, the decompressive release of supercritical carbon dioxide during spr...

Current Process HVOF thermal spray is widely used for coating critical wear parts like landing gear, bearing races, valves and turbine components. Generally, fully or partially molten metal, composite, or ceramic droplets are propelled from a gun or torch onto the workpiece. Multiple passes are required to build up the coating, since each pass only deposits ~ 0.0002 in 0.0005 in thickness of ma...

different amounts of nanoclay were incorporated into the acrylic resin matrix at 0, 1, 3, and 5 wt.% loadings. the coatings were applied on low carbon steel plates. optical microscopy, sedimentation test, transmission electron microscopy, and x-ray diffraction were employed to investigate the dispersion of nanoclay in matrix. the corrosion resistance of coatings was evaluated by electrochemical...

several investigations have been devoted towards understanding the coating process in fluidized beds. most of these studies focused on spraying liquid droplets over the bed. however, due to the complexity of these systems, more investigations are still required to quantify the effect of operating conditions on the coating criteria. the present work aims at fundamentally understanding and precis...

A novel in-line technique utilising pulsed terahertz radiation for direct measurement of the film coating thickness of individual tablets during the coating process was previously developed and demonstrated on a production-scale coater. Here, we use this technique to monitor the evolution of tablet film coating thickness and its inter-tablet variability during the coating process under a number...