Wall-to-bed (or wall-to-fluid) heat transfer issues in trickle bed reactors (TBR) has an important impact on operation and efficiency in this category of reactors. In this study, the hydrodynamic and thermal behavior of trickle bed reactors was simulated by means of computational fluid dynamics (CFD) technique. The multiphase behavior of trickle bed reactor was studied by the implementation of ...

A computer model for a hot gas-fluidized bed has been developed. The theoretical description is based on a two-fluid model ( TFM) approach in which both phases are considered to be continuous and fully interpenetrating. Local wall-to-bed heattransfer coefficients have been calculated by the simultaneous solution of the TFM conservation of mass, momentum and thermal energy equations. Preliminary...

using of nanofluids and ducts with corrugated walls are both supposed to enhance heat transfer, by increasing the heat transfer fluid conductivity and the heat transfer area respectively. use of a diverging duct with a jet at inlet section may further increase heat transfer by creating recirculation zones inside the duct. in this work two-dimensional incompressible laminar flow of a nanofluid e...

the presence of particles in liquid-solid fluidized beds enhances the bed heat transfer, because the movement of the particles leads to an increased turbulence in the system. moreover, the violent movement of the particles has a positive effect on fouling of the heat transfer surface. the aim of this investigation was to perform systematic measurements of bed voidage and heat transfer coefficie...

Experiments were conducted in a 76 mm diameter jacketed riser of a dual-loop high-density circulating fluidized bed facility with FCC particles of 65 lm Sauter mean diameter as bed material. The suspension temperature and the average and local suspension-to-wall heat transfer coefficients were measured. After superimposing the heat transfer results when the suspension near the wall is allowed t...

Using of nanofluids and ducts with corrugated walls are both supposed to enhance heat transfer, by increasing the heat transfer fluid conductivity and the heat transfer area respectively. Use of a diverging duct with a jet at inlet section may further increase heat transfer by creating recirculation zones inside the duct. In this work two-dimensional incompressible laminar flow of a nanofluid e...

Using of nanofluids and ducts with corrugated walls are both supposed to enhance heat transfer, by increasing the heat transfer fluid conductivity and the heat transfer area respectively. Use of a diverging duct with a jet at inlet section may further increase heat transfer by creating recirculation zones inside the duct. In this work two-dimensional incompressible laminar flow of a nanofluid e...