A zero voltage switching (ZVS) dc–dc converter with high voltage gain is proposed. It consists of a ZVS boost switch cell converter stage and a ZVS half-bridge converter stage with resonant converter and all these stages are merged into a single stage. The ZVS boost converter stage provides a continuous input current and ZVS operation of the power switches. The ZVS halfbridge converter stage pr...

Since 2004 German universities have been able to use a selection procedure to admit up to 60 percent of new students. In 2005, the Carl Gustav Carus Faculty of Medicine at Dresden introduced a new admission procedure. In order to take account of cognitive as well as non-cognitive competencies the Faculty used the following selection criteria based on the legal regulations for university-admissi...

A new auxiliary circuit that can be implemented in DC-DC and AC-DC ZVS-PWM converters is proposed in the paper. The circuit is for ZVS-PWM converters used in applications where high-frequency operation is needed and the load current is higher than that of typical ZVS-PWM converters. In the paper, the operation of a new ZVS-PWM converter is described, its steady-state operation is analyzed, and ...

Design considerations and performance evaluations of a three-phase, four-switch, single-stage, isolated zero-voltage-switching (ZVS) rectifier are presented. The circuit is obtained by integrating the three-phase, two-switch, ZVS, discontinuous-current-mode (DCM), boost power-factorcorrection (PFC) rectifier, named for short the TAIPEI rectifier, with the ZVS full-bridge (FB) phase-shift dc/dc ...

Magnetic components are important parts of the phase shifted full bridge (PSFB) converter. During the dead-time of switches located in the same leg, the converter can achieve zero-voltage-switching (ZVS) by using the energies stored in magnetic components to discharge or charge the output capacitances of switches. Dead-time is usually calculated under a given set of pre-defined load condition w...

The phase shift full bridge (PSFB) converter allows high efficiency power conversion at high frequencies through zero voltage switching (ZVS); the parasitic drain-to-source capacitance of the MOSFET is discharged by a resonant inductance before the switch is gated resulting in near zero turn-on switching losses. Typically, an extra inductance is added to the leakage inductance of a transformer ...

Abstract: In this paper, a reflex charger with zero-voltage-switching (ZVS) and non-dissipative cells for photovoltaic (PV) energy conversion is presented. The proposed reflex charger has the following advantages: (1) A ZVS cell is incorporated to reduce the switching losses of the main and auxiliary switches. Therefore, the conversion efficiency of the proposed reflex charger can be improved s...

This paper presents the analysis of a ZVS PWM Three-Phase Inverter with active voltage clamping technique using the reverse recovery energy of the diodes to improve the converter efficiency. The structure is particularly simple and robust. It is very attractive for Three Phase high power applications. Conduction and commutation losses are reduced due to implementation of a simple active snubber...

Inductor Inductor Capacitor (LLC) resonant converter has gained attention of researchers and engineers these days High efficiency, power density and Reliability. LLC resonant converter is most suitable resonant converter for front end DC-DC applications. Integrated magnetic, ZVS and high frequency operation, make the converter more compact and efficient. In this paper brief analysis of the LLC ...