The oxidation of aluminum single crystals is studied using molecular dynamics (MD) simulations with dynamic charge transfer between atoms. The simulations are performed on three aluminum low-index surfaces ((100), (110) and (111)) at room temperature. The results show that the oxide film growth kinetics is independent of the crystallographic orientation under the present conditions. Beyond a tr...

Metallic gallium dissolves slowly in dilute mineral acids but rapidly in aqua regia and concentrated sodium hydroxide. In its compounds, the valency is +3. Its oxygen compounds resemble those of aluminum in that there are highand lowtemperature forms of Ga2O3 and two hydroxides, Ga(OH)3 and GaO·OH. Substances which lower the hydrogen ion concentration throw down a white gelatinous precipitate f...

Chitosan is known for its hemostatic and antimicrobial properties and might be useful for temporary coating of removable dentures or intraoral splints to control bleeding after oral surgery or as a supportive treatment in denture stomatitis. This study investigated a new method to adhere chitosan to polymethyl methacrylate (PMMA) and polyethylene terephthalate (PET). There were 70 cylindrical s...

Porous alumina films had been fabricated by anodizing from aluminum films after an electropolishing procedure. Alumina stripes without pores can be distinguished on the surface of the porous alumina films. The width of the alumina stripes increases proportionally with the anodizing voltage. And the pores tend to be initiated close to the alumina stripes. These phenomena can be ascribed to the e...

The production of aluminum billetsdstarting from the conversion of bauxite to alumina, the processing of alumina to aluminum, and the final cast productdis studied using a Life Cycle Assessment (LCA) approach. The aluminum supply chain consists of a refinery, a smelter, and a casting plant. In the LCA model, the environmental loads of four different case scenarios were investigated. The scenari...

In this work, the characteristics of flow and heat transfer of a fluid containing nano particles of aluminum oxide with the water volume fraction (0.1-0.2-0.3)(V/V) percent of the reports. The overall heat transfer coefficient, heat transfer and the average heat transfer fluid containing nano water - aluminum oxide in a horizontal double pipe counter flow heat exchanger under turbulent flow con...

Surfaces of thin oxide films were investigated by means of a dual mode NC-AFM/STM. Apart from imaging the surface termination by NC-AFM with atomic resolution, point defects in magnesium oxide on Ag(001) and line defects in aluminum oxide on NiAl(110), respectively, were thoroughly studied. The contact potential was determined by Kelvin probe force microscopy (KPFM) and the electronic structure ...

This study examined the average surface roughness (Ra, microm) of 2 microfilled (Durafill and Perfection), 1 hybrid (Filtek Z250) and 2 packable composite resins (Surefil and Fill Magic), before (baseline) and after eight different finishing and polishing treatments. The surface roughness was assessed using a profilometer. Ten specimens of each composite resin were randomly subjected to one of ...

A double column procedure was devised for simultaneous estimation of norepinephrine, normetanephrine, dopamine, 3-methoxytyramine, and 5-hydroxytryptamine in brain tissue. Columns of aluminum oxide were placed on columns of Amberlite CG-50 by use of a specially devised column holder so that the effluent from the upper columns could flow directly into the lower ones. Perchloric acid extracts of ...

Sandwich structures of aluminum oxide, nickel, and aluminum oxide films are fabricated by atomic layer deposition to study thermal interfacial resistance between a metal and a dielectric material and the interfacial coupling effect across a thin metal layer. Thermal resistance of a thin nickel layer as well as two interfaces is measured using the 3x method. Experimental results show interfacial...