Power electronic converter systems for applications such as telecom, automotive, and space can have dc voltage buses that are backed up with batteries or super-capacitors. These batteries or super-capacitors are connected to the buses with bidirectional dc–dc converters which allow them to discharged or charged, depending on the operating conditions. Bidirectional dc–dc converters may be isolat...

Illumination non-homogeneity is the main problem which affects dense-array CPV systems. In a previous work we theoretically showed that connecting each cell in the array to a DC–DC converter module, leads to an increase of the power transfer efficiency with respect to classical series connection. This finding is here confirmed by two experiments making use of a cells’ array, one for a certain c...

This paper proposes a novel auto-reset forward DC-DC converter with inductor-switching technique to obtain the high performance by means of zero voltage switching and the fast transient response at steep load variations. The performance of the forward converter is strongly depending on the transformer reset-method. The Auto-reset method is used to recover the energy stored in leakage inductance...

This paper presents a step up DC-to-DC converter with hybrid switch capacitor technique having high voltage conversion ratio with small switch voltage stress . The converter is suitable for the applications where high voltage conversion is required. The proposed DC-DC converter has low voltage ratted MOSFET switch and is connected to PV array to get high output voltage at small duty ratios. Hen...

If the lines which connect the output terminal of DC-DC converter and the load are long, the voltage actually across load will be changed largely to produce the voltage drops by the impedances of the lines. Then, the terminal which senses the voltage across load is prepared apart from the output terminal of DC-DC converter, and it leads to the load, and the voltage across load is adjusted so th...

A new auxiliary circuit that can be implemented in DC-DC and AC-DC ZVS-PWM converters is proposed in the paper. The circuit is for ZVS-PWM converters used in applications where high-frequency operation is needed and the load current is higher than that of typical ZVS-PWM converters. In the paper, the operation of a new ZVS-PWM converter is described, its steady-state operation is analyzed, and ...

Josephson [8] predicted in 1962 that a DC tunnel current would flow between two superconductors connected by a thin insulating layer of thickness less than about 20 Å in the absence of a voltage difference, an effect now called the DC Josephson effect. The quantum-mechanical current, called the superconducting current, arises from the tunneling of Cooper pairs of electrons of opposite spin and ...

In this work, the application of numerical device simulation to the analysis of high resistivity silicon microstrip detectors is illustrated. The analysis of dc, ac and transient responses of a single-sided, dc-coupled detector has been carried out, providing results in good agreement with experimental data. In particular, transient-mode simulation has been exploited to investigate the collecti...

Ideal power converters are governed by differential equations with discontinuous right-hand sides. General-purpose algorithms to compute their Lyapunov exponents assume smooth equations, so are not directly applicable to power electronics. We review the methods and their problems, focusing on the largest Lyapunov exponent, which dominates system behavior. The variational approach can incorporat...