Physicochemical properties of pozzolan Portland cement were compared to ProRoot MTA and MTA BIO. To test the pH, the samples were immersed in distilled water for different periods of time. After the pH analysis, the sample was retained in the plastic recipient, and the electrical conductivity of the solution was measured. The solubility and radiopacity properties were evaluated according to spe...

The authors presented their data from atomic absorption tests, stating that the cements released less than 0.0007 ppm of arsenic after a week of soaking in weakly acidic solution. That is, the cements released 0.7 ppb from their worst sample. My first comment is on the atomic absorption technique for arsenic. According to the EPA method 7062 for detection of arsenic by atomic absorption using s...

A computerized dental model was used to study the stress induced in a Class 1 amalgam restoration when supported by bases of varying materials and thickness. Under the same load, the maximum tensile stresses and deflections in the amalgam restoration increased at least threefold with a zinc oxide-eugenol base as compared with a ZnPO4 cement base.

OBJECTIVES The bond of adhesive luting cements to the tooth tissues and restorative materials is expected to hinder their transverse contraction for the layer thickness applied in dental restorations. It was hypothesized that the hindering of the transverse deformation will influence the relation between stress and strain (the stiffness) in the direction perpendicular to the substrate surface. ...

AIM The objective of this study is to investigate the effect of different luting agents on the fracture strength of Turkom-Cera all-ceramic copings. METHODS AND MATERIALS Standardized metal dies were duplicated from a prepared maxillary first premolar tooth using non-precious metal alloy (Wiron 99). Thirty Turkom-Cera copings of 0.6 mm thickness were then fabricated. Three types of luting age...

Introduction Glass Ionomer Cements (GIC) are widely used dental materials. They adhere to hard dental tissues, release fluoride ions and are bio-compatible [ 11. GIC are obtained from the reaction during the hardening process between a polymeric acid and acid-degradable glass. Water plays a crucial role in this reaction; its absence retards or prevents the reaction while high concentrations res...

Although there are sufficient dentists in the world today, the majority of people do not have access to adequate, affordable, and acceptable oral health services. Discussions about the effectiveness of dental procedures and dental care in general are dominated by the concerns of dentists in industrialized countries. Are lasers useful in periodontal treatment? Which glass-ionomer cement should b...

Disintegrating the adhesive bridge from the abutment is one of the most uncomfortable consequences for the patient, and especially for the therapeutist, as it arises a question on the justifiability of the applied method. The success of these appliances depends on the design of the metal skelet, the strenght of the cement itself, as well as its bonding with the etched enamel and the dental allo...

background: the clinical success of sandwich technique depends on the strength of resin-modified glass ionomer cement (rmgic) bonding to both dentin and resin composite. therefore, the shear bond strength (sbs) of resin composite bonded to rmgic utilizing different resin adhesives versus a gic-based adhesive was compared. materials and methods: in this in vitro study, 84 holes (5×2 mm) were pre...