This study compared the fracture toughness values (KIC), which were derived from simplified techniques: the indentation fracture (IF), the indentation strength (IS), and fractographic approach to that from a standard testing using surface cracks in flexure (SCF). Forty bar specimens, twenty IPS Empress(®) Esthetic and twenty IPS e.max(®)Ceram were prepared. Ten specimens in each material were t...

The objective of this study was to measure the mechanical properties of individual, native wood fibers using the continuous nanoindentation measurement technique. The indentation depth profile exhibited a small length-scale effect, which was confirmed using the size-effect index derived from the indentation loading curve. The hardness (Hu) or stiffness (Eu) values determined from indentation un...

Nanoindentation tests were carried out to measure the elastic modulus of rat whisker, which is used as a high-acuity sensor for exploring the world and discriminating object distance, size and surface texture. The measured load–depth curves show that the biomaterial of rat whisker exhibits obvious visco-elastic characteristic, such as load relaxation and displacement creeping. The measured inde...

We report on the results of a comparative study in which the mechanical response of both fully dense and porous lowdielectric thin films was evaluated using two different techniques: nanoindentation and the plane-strain bulge test. Stiffness values measured by nanoindentation are systematically higher than those obtained using the bulge test technique. The difference between the measurements is...

We use the Stroh formalism to study analytically generalized plane strain deformations of a linear elastic anisotropic layer bonded to a rigid substrate, and indented by a rigid cylindrical indenter. The mixed boundary-value problem is challenging since the a priori unknown deformed indented surface of the layer contacting the rigid cylinder is to be determined as a part of the solution of the ...

This work explores the effect of surface modification of stainless steel with a carbon nitride (CNx) film, under sliding wear of the UHMWPE/steel. Wettatibility of CNx coatings is assessed by means of the sessile drop method using two different liquid media. Microhardness and stiffness of CNx coatings are estimated by depth-sensing indentation. The sliding performance of UHMWPE against stainles...

Edward J. Nicolson and Ronald S. Fearing Department of EE&CS University of California Berkeley, CA 94720 Abstract A linear elastic plane strain model for a cylindrical nger with a solid core and elastic surface is developed. This model is used to determine the subsurface strain impulse responses as well as pressure distributions in the contact region for indentation of the cylinder by rigid obj...

Systematic experiments have been performed to investigate the rate sensitivity of deformation in fully dense nanocrystalline Ni using two different experimental techniques: depth-sensing indentation and tensile testing. Results from both types of tests reveal that the strain-rate sensitivity is a strong function of grain size. Specifically microcrystalline and ultra-fine crystalline pure Ni, wi...

It is crucial to understand the creep behavior of Pb-free solder alloys in electronic packaging. Typical service environments are between 298 and 373K. The thermal mismatch induced stresses acting on solder joints result in extensive rate-dependent plastic deformation. The solder alloy is potentially the weakest component in the electronic package because normal operating temperatures are alrea...

Article history: Received: 31.01.2013. Received in revised form: 08.02.2013. Accepted: 08.02.2013. The indentation response of a closed-cell Al foam under the flat-end cylindrical indenter was experimentally investigated. The effects of indenter sizes, relative density of Al foam and boundary condition on the mechanical and energy absorption characteristics of indentation were also investigated...