Measurement of the strength of brittle materials, such as resin composites, is extremely difficult. Micro-indentation hardness testing is a convenient way of investigating the mechanical properties of a small volume of material. In this study, the mechanical properties of five commercially available flowable resin composites were investigated by the dynamic micro-indentation method. Additionall...

The mechanics governing the lateral cracks that form when a hard object plastically penetrates a ceramic is presented. The roles of indentation load, penetration depth, and work of indentation are all highlighted, as are the influences of the mechanical properties of the material. A closed form solution for cracking induced by expansion of a two-dimensional cavity is used to bring out essential...

This paper describes a method for evaluating material properties of multi-layered system and functional gradient materials from data obtained from indentation testing. The measurement data collected from the penetration force-depth curves is employed for identifying elastic moduli of thin films and functional gradient materials. An axisymmetric indentation problem is first analyzed on the basis...

Atomic Force Microscopy (AFM) indentation on living cells in physiological medium is a well established technique used for investigation of the cell mechanical properties at nanoscale. However, interpretation of the experimental data obtained in such experiments is rarely a trivial task. This is happening because living cells have a complex response to the applied mechanical stress, response th...

The atomic force microscopy (AFM) has been widely used to measure the mechanical properties of biological cells through indentations. In most of existing studies, the cell is supposed to be linear elastic within the small strain regime when analyzing the AFM indentation data. However, in experimental situations, the roles of large deformation and surface tension of cells should be taken into co...

Results are reported from two molecular-dynamics simulations designed to yield insight into the engineering of nanometre-scale structures. The first is the initial stages of the indentation of a silicon substrate by an atomically-sharp diamond tip. Up to an indentation depth of approximately 0.6 nm the substrate responds elastically and the profile of the disturbed region of the substrate norma...

The techniques commonly used for observing the deformation mechanisms underneath a Vickers indentation in metallic glasses (chemical etching, bonded interface) induce artefacts such as cracks or semi-circular shear-bands. We propose an alternative technique based on the propagation of indentation corner cracks through a pre-existing imprint, which is possible in metallic glasses such as iron-ba...

We proposed a tactile and proximity sensor (layered 3D touch screen) base on capacitance measurement. In the proposed sensor, the parallel-type capacitance sensor and plane-type capacitance sensor are layered. The sensor can detect the object and position before contact (proximity range), and can detect the indentation and precise position on contact. In addition, it can discriminate materials ...

Strain rate dependence of indentation hardness has been widely used to study time-dependent plasticity. However, the currently available techniques limit the range of strain rates that can be achieved during indentation testing. Recent advances in electronics have enabled nanomechanical measurements with very low noise levels (sub nanometer) at fast time constants (20 µs) and high data acquisit...

The purpose of this study was to investigate and analyse the fracture toughness of yttria stabilized tetragonal zirconia polycrystal (Y-TZP) dental ceramics by means of the Vickers indentation technique. Fracture toughness was analysed under the following loads: 29.42 N, 49.03 N, 196.13 N, and 294.20 N. Cracks that had developed from the vertices of a Vickers indentation were measured and used ...