In this study, four protective coating materials: Inconel 718, 625, Alloy 33 and Stellite 6 were deposited on 16Mo3 steel tubes by means of CMT (Cold Metal Transfer), as an advanced version MAG (Metal Active Gas) welding method. the next step, surface was remelted TIG (Tungsten Inert SEM microstructure coatings–substrate has been reported, EDX-researched chemical composition coatings compared t...

the plain carbon steel “ck45” has relatively well mechanical and metallurgical properties and low cost. the purpose of this research was the property evaluation of this steel on abrasive wear and impact for using in plows and other tillage tools. tillage tool should resist in abrasive wear and impact simultaneously. several heat treatments were done on specimens of this steel. a standard test d...

Today, rapid economic and industrial growth generates increasing amounts of waste materials such as waste tyre rubber. Attempts to inspire a green technology which is more environmentally friendly that can produce economic value are a major consideration in the utilization of waste materials. The aim of this study is to evaluate the effect of waste tyre rubber (crumb rubber modifier (CRM)), in ...

This paper presents the characterization of a secondary cone crusher concave liner made Hadfield steel used in Chilean mining after crushing copper minerals during all service life. During use, suffers indentation (cold working) and abrasion; this combination provides with layer that constantly renews itself, maintaining surface highly resistant to abrasive wear. The results presented here were...

The purpose of this study is to understand the nonlinear dynamics of longitudinal ground vehicle traction. Specifically, single-wheel models of rubber-tired automobiles under straight-ahead braking and acceleration conditions are investigated in detail. Customarily, the forward vehicle speed and the rotational rate of the tire/wheel are taken as dynamic states. This paper motivates an alternati...

tillage and press wheel weight play an important role in seedling emergence, crop establishment and growth. an optimal combination of tillage implements and suitable press wheel weights should increase grain yield. this study investigated the effect of tillage systems and press wheel weights on dry land wheat (triticum aestivum l.) seedling emergence and grain yields in izeh, khuzestan province...

In this paper, validation of a model for the speed dependency of friction is presented. Based on the shape of the friction – speed curve, the model assumes that calculation of friction at any speed would need an estimate of friction at very low speed, and the knowledge of its variation with speed described by the Stribeck curve. Two existing models developed at LCPC are then coupled to predict ...

During fabrication of bonded ceramic restorations, cervical adaptation, occlusal adjustment and final finishing/polishing are procedures to be performed at the dental office after adhesive cementation. Final adjustments may result in loss of ceramic glaze, which requires new polishing of the ceramic surface, with special attention for selection of adequate materials and instruments. The purpose...

Silicone rubber insulators are replacing the conventional ceramic and porcelain insulators rapidly in power transmission and distribution industry. Very limited field knowledge is available about the performance of silicone rubber insulators in polluted and contaminated environments and therefore need further investigation. A comprehensive analysis of silicone rubber sheets (intended for coatin...

Rubber industry has increased the requirements for quality and uniformity of natural rubber produced in Brazil. Technological properties of latex and natural rubber of clones GT 1, PB 235, IAN 873 and RRIM 600 [Hevea brasiliensis (Willd. Former Adr. de Juss.) Muell.Arg] were evaluated by standard methods of the dry rubber content (DRC%), percentage of nitrogen (N%) and percentage of ashes (ASH%...