forming limit curve (flc) is an important tool for evaluation of formability of sheet metals subjected to different loading. free bulge of aluminume tubes has been investigated numerically to obtain flc. to verify the numerical results one experimental setup has been manufactured which has the ability of controlling the internal pressure and axial feed. in this study, time and zone of bursting ...

Fracture and fatigue properties are examined for a series of Mo–Mo3Si–Mo5SiB2 alloys, which utilize a continuous a-Mo matrix to achieve unprecedented room-temperature fracture resistance (>20 MPa p m). Mechanistically, these properties are explained in terms of toughening by crack trapping and crack bridging by the more ductile a-Mo phase. 2003 Acta Materialia Inc. Published by Elsevier Ltd. Al...

We have demonstrated the ability to perform a ductile material removal operation, via single-point diamond turning, on single-crystal silicon carbide (6H). To our knowledge, this is the first reported work on the ductile machining of single-crystal silicon carbide (SiC). SiC experiences a ductile-to-brittle transition similar to other nominally brittle materials such as silicon, germanium, and ...

This letter describes a newly discovered phenomenon: ductile fracture in cementitious materials. The brittle nature of materials such as concrete and ceramics has prompted the development of various approaches to enhance their fracture toughness. Fibre reinforcement has been the common focus in the toughening of the brittle materials. Two types of fracture have been observed to date in cementit...

Addition of titanium (Ti) to ASTM A710 Grade B Cu-precipitation-strengthened steel significantly increases the impact absorbed fracture energy and reduces the ductile-to-brittle transition temperature. The effect of Ti correlates with the reduction of the amount of pearlite in the ferritic microstructure. A thorough study of the mechanical properties of Ti-modified A 710B steel is presented. In...

At low temperatures silicon is a brittle material that shatters catastrophically, whereas at elevated temperatures, the behavior of silicon changes drastically over a narrow temperature range and suddenly becomes ductile. This brittle-to-ductile transition has been observed in experimental studies, yet its fundamental mechanisms remain unknown. Here we report an atomistic-level study of a funda...

The strength and durability of adhesively bonded sandwich structures often depend on the mechanisms of fracture, which in turn depend on the properties of the adhesive and the microstructures of the interface. When the thin adhesive layer is ductile, cavitation either within the layer or along the interface is often the dominant failure mechanism. In the present paper, fracture due to cavity gr...

The effect of loading rate on the plane stress fracture toughness properties of a 3.2-mm thick 2219-T87 aluminum alloy plate was investigated with center-cracked panels. Plane-stress J-resistance curves were generated at a constant displacement rate of 10-6 and 5.7 m s-l. Dynamic fracture testing was performed with a coupled pressure plates technique. Fracture initiation and propagation toughne...

Low-velocity plate impact experiments using a single-stage gas-gun are performed on Zr58.5Cu15.6Ni12.8Al10.3Nb2.8. Compressive fracture surfaces of the samples subjected to varying impact velocities and stress amplitudes are evaluated in order to study their loading rate dependence. Samples impacted at increasing loading rates, from increasing velocities of impact, show a larger extent of local...