For application of the plastic analysis and design methods the control of the plastic behaviour of the structures is an important requirement. In this study, the complementary strain energy of the residual forces is considered as an overall measure of the plastic performance of the structure. Shakedown theorem for the analysis of the plastic behaviour of the laterally loaded piles is developed ...

An analytical method for predicting elastic–plastic stress distribution in a cylindrical pressure vessel has been presented. The vessel material was a ceramic/metal functionally graded material, i.e. a particle–reinforcement composite. It was assumed that the material’s plastic deformation follows an isotropic strain-hardening rule based on the von-Mises yield criterion, and that the vessel was...

In hot forming process, the workpiece undergoes plastic deformation at high temperature and the microstructure of the workpiece changes according to the plastic deformation. These changes affect the mechanical properties of workpiece. In order to optimize this process, both the plastic deformation of workpiece and its microstructural changes should be taken into consideration. Since material be...

in this paper, the correlation between the surface rumpling and cracking phenomena with twinning mechanism during plastic deformation of hadfield steel has been investigated. the effect of stacking fault energy and the amount of strain are evaluated. the experimental samples with specific amounts of carbon, manganese and aluminum resulting in different stacking fault energies, were produced usi...

the built up layer thickness in secondary deformation zone is one of the important parameters in metal cutting process. the built up layer (bul) is formed in second deformation zone near the tool-chip interface in the back of the chip. this parameter influences the tool life and machined surface quality. this bul should not be confused with the built up edge (bue). the deformation of the bul in...

A COMMON APPROACH used in formulating elastoplastic constitutive equations is to partition the total strain rate into its elastic and plastic parts, and then develop the constitutive expression for the plastic strain rate using the concept of the yield surFace in stress space. An alternative approach is to partition the stress rate into its elastic and plastic parts, and then develop the consti...

A study is made into the effect of the critical current density dependence upon the value of plastic strain on the critical state stability in hard and composite superconductors under conditions of plastic yield of the material. There have been found criteria of the critical state stability relative to the jointly developing magnetic flux jumps and plastic strain jerks.

Hysteresis loop curves are highly important for numerical simulations of materials deformation under cyclic loadings. The models mainly take account of only the tensile half of the stabilized cycle in hysteresis loop for identification of the constants which don’t vary with accumulation of plastic strain and strain range of the hysteresis loop. This approach may be quite erroneous particularly ...

The Fe-Cr-Ni stainless steels are well known for their ductile behaviour at cryogenic temperatures. This implies development and evolution of plastic strain fields in the stainless steel components subjected to thermo-mechanical loads at low temperatures. The evolution of plastic strain fields is usually associated with two phenomena: ductile damage and strain induced martensitic transformation...

A new plastic hinge integration method overcomes the problems with nonobjective response caused by strain-softening behavior in force-based beam–column finite elements. The integration method uses the common concept of a plastic hinge length in a numerically consistent manner. The method, derived from the Gauss–Radau quadrature rule, integrates deformations over specified plastic hinge lengths ...