In the present investigation, various kinds of textures, namely, unidirectional, 8-ground, and random were attained on the die surfaces. Roughness of the textures was varied using different grits of emery papers or polishing powders. Then pins made of Al-4Mg alloys were slid against steel plates at various numbers of cycles, namely, 1, 3, 5, 10 and 20 using pin-on-plate reciprocating sliding te...

A new dynamic friction force model for the longitudinal road/tire interaction for wheeled ground vehicles is validated via experiments with an actual passenger vehicle. Contrary to common static friction/slip maps, this new dynamic friction model is able to accurately capture the transient behavior of the friction force observed during transitions between braking and acceleration. A velocitydep...

The friction coefficient is an important parameter in designing magnetic tape transports. We have introduced laser surface texturing to reduce the friction coefficient between guides and magnetic tape. The surface features enhance the formation of an air bearing and hence, reduce the friction coefficient. INTRODUCTION Lateral tape motion (LTM) is defined as the time-dependent motion of the tape...

Loosening of the artificial cup and inlay is the most common reasons for total hip replacement failures. Polyethylene wear and aseptic loosening are frequent reasons. Furthermore, over the past few decades, the population of patients receiving total hip replacements has become younger and more active. Hence, a higher level of activity may include an increased risk of implant loosening as a resu...

A rigorous proof for existence and uniqueness of solutions to a class of singular nonlinear boundary value problems arising in viscous flow and heat transfer behind a shock wave is made and a theoretical estimate formula for the skin friction coefficient is presented. The formula can be successfully applied to estimate the value of the skin friction coefficient. The correctness of the analytica...

(1) An apparatus has been constructed to measure the coefficient of friction of synovial membrane against a glass slider. (2) Provision was made to vary the load on the specimens. (3) The coefficient of friction varied from 0-006 to 0-07. (4) A presentation similar to that used in the Sommerfeld analysis of journal bearings indicated that in these experiments synovial membrane was lubricated in...

A micromechanical study is made of the relationship between interparticle friction coefficient and macroscopic continuum friction and dissipation in idealised granular materials, using Discrete Element Method simulations with varying . As expected, macroscopic friction and dilatancy increase with . Surprisingly, dissipation is present even when or when . Hence, dissipation in idealised granular...