An experiment is conducted in which a free-standing bicycle wheel is given an initial angular speed and then allowed to slow down to rest. Measurements of the wheel speed, using a magnetic sensor, during the decay are compared to predictions from a model accounting for a combination of viscous and dry friction at the wheel bearing. The time history data indicate two dynamic regimes: (i) a highe...

We propose a simple rubber friction law, which can be used, for example, in models of tire (and vehicle) dynamics. The friction law is tested by comparing numerical results to the full rubber friction theory (Persson 2006 J. Phys.: Condens. Matter 18 7789). Good agreement is found between the two theories. We describe a two-dimensional (2D) tire model which combines the rubber friction model wi...

The most often used friction model for sheet metal forming simulations is the relative simple Coulomb friction model. This paper presents a more advanced friction model for large scale forming simulations based on the surface change on the micro-scale. The surface texture of a material changes if two surfaces are in contact under a normal load which is an effect of flattening due to normal load...

The most often used friction model for sheet metal forming simulations is the relative simple Coulomb friction model. This paper presents a more advanced friction model for large scale forming simulations based on the surface change on the micro-scale. The surface texture of a material changes when two surfaces are in contact under a normal load. This is caused by flattening due to combined nor...

Original scientific paper In this paper, the orthogonal cutting force model is proposed comprising forces due to flank wear in addition to the forces for chip formation during the hard turning of round bar made of steel 60WCrV7 hardened at 55+2HRc. Cutting force model includes two tool conditions: perfectly sharp tool with VBB = 0 and tool with maximum permissible flank wear VBBmax. Based on cu...

This paper describes two approaches for the simultaneous identification of the coulomb and viscous parameters in kinematical joints. One is a time-domain method (TDM) and the other is a frequency-domain method (FDM). Simulation shows that both of the two methods have good performances in identifying friction at high SNR (90dB). But at low SNR (20dB), the estimation accuracy of the frequency-dom...

In this paper, an adaptive robust control (ARC) scheme based friction compensation strategy is presented for a class of mechanical systems in the presence of dynamic friction effects. In contrast to existing deterministic robust control (DRC) and adaptive control (AC) schemes, the proposed ARC scheme utilizes both the structural information of the dynamic friction model and the available prior ...