Despite having some useful properties, stainless steels suffer from lack of suitable surface hardness. In this research electroless Ni-B-Tl coating was used with the aim to increase their surface hardness. The effects of Nickel chloride, Sodium borohydride, Thallium nitrate and Ethylendiamin on the chemical composition of coating were studied. To achieve an increase in hardness, the effects of ...

It has been reported by previous research work that in plasma spray process hydroxyapatite decomposes into some amorphous phases due to rapid cooling of the coated substrate during the coating process, which causes instability of coated implant. Post coating heat treatment has been expected to minimize these phases and also enhance the long term reliability of hydroxyapatite coatings on metal s...

In an internal combustion engine, the heat energy approximately one third of total fuel input energy is converted to useful work. Since the exhaust gas temperature is not equal environmental temperature, so lot of heat energy lost with hot gases. Also heat energy is lost in cooling of engine. If we recovered heat energy which lost in cooling instead on crankshaft as useful work, then increase t...

The zirconia stabilized by 3mol % Y2O3 (3YSZ) was applied onto the surface of the magnesium alloy AZ91D using electrophoretic deposition (EPD) from a non- aqueous solution. A Ni-P interlayer between the substrate and YSZ coating was also prepared by electroless plating. Finally, coatings were heat treated in control atmosphere at 400 °C. The preparation, microstructure and corrosion resistance ...

the synthesis of titania via sol-gel method has been widely studied. in the present work, titania was deposited onto a titanium substrate via sol-gel method. different processing parameters such as the repetition number of dipping/heat treatment process and dipping time have been studied to obtain the homogenous titania coating. phase and microstructural evaluation of the powder and coating sam...

Hot dip aluminizing was carried out on the low carbon steel rod under optimized conditions. The aluminized samples were further oxidized at 1000̊C in air atmosphere at two different times of 20 and 60 minutes. Microstructure study and phase analysis were studied by scanning electron microscopy and X-ray diffraction methods, respectively. The characterization of the coating showed that, Fe2...

The purpose of this work was to production of ceramic thin films by using of Sol-Gel process. For this purpose deposition of SiO2 on substrates of soda-lime glasses has been carried out. Coating treatments on prepared specimen were conducted in a Sol solution by means of dipping at various times. After drying and performing appropriate heat treatment on each sample, the thickness of coated laye...

As we know sol-gel is one of the most important techniques for thin film preparation. In this paper, high transmission silica thin films have been prepared by dip-coating process from a new silicon-alkoxide solution. The prepared sol was stable for 45 days which is very important to characterize the coating process. The optical properties as a function of aging time, withdrawal rate, and he...

Both blue- and redshifts of resonant modes are observed in the rolled-up Y2O3/ZrO2 tubular microcavity during a conformal oxide coating process. Our investigation based on spectral analyses suggests that there are two competitive processes during coating: desorption of both chemically and physically absorbed water molecules and increase of the tube wall thickness. The redshift is due to the inc...

The purpose of this work was to production of ceramic thin films by using of Sol-Gel process. For this purpose deposition of SiO2 on substrates of soda-lime glasses has been carried out. Coating treatments on prepared specimen were conducted in a Sol solution by means of dipping at various times. After drying and performing appropriate heat treatment on each sample, the thickness of coated laye...