Using of nanofluids and ducts with corrugated walls are both supposed to enhance heat transfer, by increasing the heat transfer fluid conductivity and the heat transfer area respectively. Use of a diverging duct with a jet at inlet section may further increase heat transfer by creating recirculation zones inside the duct. In this work two-dimensional incompressible laminar flow of a nanofluid e...

Turbulent heat transfer in Helically Corrugated Tubes (HCT) was numerically investigated for pure water and SiO2 nanofluid using Computational Fluid Dynamics (CFD). This study was carried out for different corrugating pitches (5, 7, 8 mm) and heights (0.5, 0.75, 1.25 mm) at various Reynolds numbers ranging from 5000 to 13300. The effect of nanoparticles on heat transfer augmentation for plain t...

Electrothermal energy storage (ETES) provides bulk electricity storage based on heat pump and heat engine technologies. A subcritical ETES is described in this paper. Based on the extremum principle of entransy dissipation, a geometry model is developed for heat transfer optimization for subcritical ETES. The exergy during the heat transfer process is deduced in terms of entropy production. The...

In this paper, an attempt has been made to estimate the convective heat and mass transfer for pool boiling of sugarcane juice during preparation of jaggery. An indoor experiment was conducted to measure (i) the mass of evaporated water, (ii) the temperature of the sugarcane juice, (iii) the relative humidity above the sugarcane juice surface and (iv) the temperatures at the bottom and side of t...

an analysis is carried out to investigate the effects of variable chemical reaction, thermophoresis, temperaturedependent viscosity and thermal radiation on an unsteady mhd free convective heat and mass transfer flow of a viscous, incompressible, electrically conducting fluid past an impulsively started infinite inclined porous plate by taking into account the viscous dissipation effects. the g...

In this work, experimental kinetics data of methane hydrate decomposition at temperatures ranging from 272.15 to 276.15 K and at pressures ranging from 10 to 30 bars were modeled by using chemical affinity. This model proposed a macroscopic model which is independent of any intermediate mechanism like heat or mass transfer. The results show there is good agreement with experimental data. Al...

In order to examine the laminar convective heat transfer of nanofluid, experiments carried out using silver-oil nanofluid in a concentric annulus with outer constant heat flux as boundary condition. Silver-oil nanofluid prepared by Electrical Explosion of Wire technique and observed no nanoparticles agglomeration during nanofluid preparation process and carried out experiments. The average size...

The potential of nanofluids for the improvement of heat transfer coefficient in various heat exchangeequipment has been considered and studied as a major application during recent decades. In this research,heat transfer coefficient of ZnO, TiO2 and ZnO/TiO2 nanofluids in a shell and tube heat exchanger has beenstudied experimentally. ZnO nanoparticle was synthesized through pre...