Boiling is a common mechanism for liquid-vapor phase transition and is widely exploited in power generation and refrigeration devices and systems. The efficacy of boiling heat transfer is characterized by two parameters: (a) heat transfer coefficient (HTC) or the thermal conductance; (b) the critical heat flux (CHF) limit that demarcates the transition from high HTC to very low HTC. While incre...

The enhancement of boiling heat transfer, the most powerful energy-transferring technology, will lead to milestones in the development of high-efficiency, next-generation energy systems. Perceiving nano-inspired interface functionalities from their rough morphologies, we demonstrate interface-induced liquid refreshing is essential to improve heat transfer by intrinsically avoiding Leidenfrost p...

The heat transfer coefficient (HTC) is a very important factor influencing the energy performance of building. Recent studies have shown importance on-site measurements HTC in reducing gap buildings. However, its measurement setup and calculation procedures are known to be intense complex. Due this, many stakeholders building industry find it impractical insufficient for their needs. This paper...

In this article, stream flow effectivness is based on hydraulic network studied in the shell-side of a shell and tube heat exchange as a case study. For an appropriate heat exchangers rating design to meet a specified duty, it's better to consider each stream flow separately. Using the hydraulic network principals, a set of the correlations for calculating different stream flow rates in the cro...

Cast aluminum alloys are usually subject to solution treatment, quenching, and aging hardening for improved mechanical properties. Cooling rate during quenching plays an important role in residual stress, distortion, and mechanical property distributions in the resultant cast aluminum components. As the cooling rates of work pieces heavily depend on the interfacial heat transfer coefficient (HT...

Turbulent heat transfer in Helically Corrugated Tubes (HCT) was numerically investigated for pure water and SiO2 nanofluid using Computational Fluid Dynamics (CFD). This study was carried out for different corrugating pitches (5, 7, 8 mm) and heights (0.5, 0.75, 1.25 mm) at various Reynolds numbers ranging from 5000 to 13300. The effect of nanoparticles on heat transfer augmentation for plain t...

In the research of heat transfer, exchanger plays an important role in highly integrated and high-precision thermal management to ensure balance. previous studies, traditional experiments CFD simulations consume lots time computational resources, while transfer correlations have large errors. Hence, this aims establish a reliable method predict Heat Transfer Coefficient (HTC) exchange channels ...

cooling towers are widely used in most industrial units to reject waste heat to the atmosphere. this paper deals with an experimental analysis of heat and mass transfer phenomena between water and air by direct contact in a cooling tower. the tower is filled with 6 type packing. in this study temperature and pressure drop and tower characteristics was used in determining experimentally the ther...

in this work, the characteristics of flow and heat transfer of a fluid containing nano particles of aluminum oxide with the water volume fraction (0.1-0.2-0.3)(v/v) percent of the reports. the overall heat transfer coefficient, heat transfer and the average heat transfer fluid containing nano water - aluminum oxide in a horizontal double pipe counter flow heat exchanger under turbulent flow con...

In this research, the heat transfer coefficient (HTC) and pressure drop of alternating cross-section flattened (ACF) tubes were investigated experimentally compared with same parameters a circular tube. Three different ACF fabricated from copper tubing an internal diameter 4.5 mm, thickness 1 length 400 mm. The twist angles 30, 45, 90°. experimental ranges covered mass flux 729–1,434 kg/m2s 12–...